ZKHTR1 Trim Kit (For 3/4″ Panels)
Support for Custom Handles
Step 1 Temporarily mount door panel
• Place the prepared 3/4″ custom door panel on the bottom trim with support bracket tabs inserted into trim slots.
• Push the panel back against the steel door, making sure the panel is flush with the hinge side trim.
• Secure the panel to the trim temporarily by
| driving 2 screws through the backside of the |
|
|
|
|
|
|
|
|
| trim at the top. |
|
|
|
|
|
|
|
|
| • Slide the handle extrusion in between the panel |
|
|
|
|
|
|
|
|
| and steel door. |
|
|
|
|
|
|
|
|
| • Temporarily secure the extrusion to the door with |
|
|
|
|
|
|
|
|
| 2 screws. |
|
|
|
|
|
|
|
|
Step 2 |
|
|
|
|
|
|
|
|
|
• Determine the location of the custom |
|
|
|
|
|
|
|
| |
Locate | handles and carefully mark centerlines |
|
|
|
|
|
|
|
|
position | of the screw holes. The handles must be |
|
|
|
|
|
|
|
|
of handle | located 3/4″ to |
|
|
|
|
|
|
|
|
| the extrusion. |
|
|
|
|
|
|
|
|
| • Drill 1/16″ pilot hole through the panel until |
|
|
|
|
|
|
|
|
| it starts into the aluminum extrusion. This |
|
|
|
|
|
|
|
|
| will mark the matching location for drilling |
|
|
|
|
|
|
|
|
| a clearance hole when assembling the |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| extrusion, panel and handle. |
|
|
|
|
|
|
| 3/4" Min. |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
Step 3 | • Remove the handle extrusion, the 2 temporary |
| |
Assemble | screws and custom panel. |
| |
panel, | • Drill 1/16″ pilot hole through extrusion. | Screw | |
extrusion | • Drill clearance holes through the panel and | ||
| |||
and handle | extrusion. |
| |
| • Assemble the panel, extrusion and custom handle. |
| |
| • Install screw(s) long enough to pass through the |
| |
| extrusion, door panel and into the handle. |
|
3/4" Min.
27
