GE ZIF36N RH, ZIR36N LH, ZIR36N RH Installation, 36″ Refrigerators, Freezers, installation height

Installation

36″ Refrigerators, Freezers

Step 8	If you are using a 3/4″ thick custom panel, SKIP THIS
Install 1/4″	STEP. See Custom Panel Dimensions pages for panel
door panels	sizes with ZKTR36LH or ZKTR36RH trim kit and other
	kits. Refer to trim kit instructions in this booklet.
	• Open door to 90° stop. Remove the Phillips head
	screws from the aluminum trim door handle.
	• Remove handle. Retain all screws and handle.
	• Slide custom panel into the door trim.
	• Replace door handle and secure with original
	screws.
Step 9	• Check to make sure power is on by opening the
Check	door to see if interior lights are on.
Power
Step 10	If you are using a 3/4″ thick custom panel, SKIP THIS
Mount	STEP. See Dimensions and Specifications for grille	Screws
Top Grille	panel sizes. Order ZKTR36LH or ZKTR36RH and follow
Panel	the installation instructions packed with the kit.
	The grille panel frame is factory assembled for an	Top Case Trim
	84″ installation height. If installation height varies,
	order ZGC2 trim kit which provides optional side trim
	pieces for 83-1/2″and 84-1/2″heights.	Raise To
		Installation
	Cut 1/4″ thick custom panel to fit the frame,	Height
	35-1/8″wide, 8″ deep (for an 84″ installation).
	To insert custom grille panel into the frame:
	• Remove screws (2 on each top corner) and “L”
	brackets on each side.
	• Slide panel into the frame and reassemble.
	• Mount the grille panel by dropping into slots on the
	case trim.
	• For shipping purposes, the top case trim is secured
	at 84″ installation height.
	To raise case trim to 84-1/2″or to lower to 83-1/2″
	installation height:
	• Loosen 2 screws on both sides and raise the top or
	lower case trim to meet soffit height or to the top of
	adjacent cabinets.
	• Tighten all 4 screws.
	1-1/2"
	min.
	gap

IMPORTANT: Maintain 1-1/2″min. gap between top of doors and bottom of panel frame.

17