ZKHRSS1 Trim Kit (For 1/4″ Panels)
| Tubular Stainless Steel Handles |
|
|
Right hand door swing models are illustrated in these | This kit provides for the installation of a Tubular |
instructions. Follow these instructions for left hand | Stainless Steel handle on 1/4" thick decorator door |
models. | panel. The door extrusions allow the handle to be |
| secured to the door structure, rather than to the |
NOTE: It is best that 2 people install this kit. | custom panel. |
| •Select extrusion for your model, discard other |
Tools and materials required: | extrusion. |
•#2 Phillips screwdriver
•Drill and appropriate bits
• Custom door panel | A | |
| ||
• Safety glasses | B | |
• Center punch | ||
• Masking tape | C | |
• Hammer | ||
|
•Pencil
•1/2″ thick 12″ x 12″ min. piece of plywood to
protect floor when drilling | D | |
• For stainless steel panel, wear gloves to protect | ||
E | ||
against sharp edges. | ||
Parts List: | F | |
| ||
A. Handle extrusion (for left hand models) | G | |
B. Handle extrusion (for right hand models) | H | |
C. Door handle | ||
| ||
D. 6 Spacer rings (for Stainless Panels ONLY) |
| |
(4 required, 2 extra) |
| |
E. 4 Handle standoffs |
|
F.6 Screws for mounting handle standoffs (4 required, 2 extra)
G.6 Set screws (4 required, 2 extra)
H.3/32″ Allen wrench for set screws
Step 1 | • Open fresh food door to 90°. Remove the screws |
Remove | from the |
handle | • Retain screws, discard handle. |
29
