GE ZIF36N RH, ZIR36N LH, ZIR36N RH, ZIF36N LH ZKHTRSS1 For 3/4″ Panels, Kit, Before you, Begin

ZKHTRSS1 (For 3/4″ Panels)

Tubular Stainless Steel Handles

Kit	Right hand door swing models are illustrated in these
Contents	instructions. Follow these instructions for left hand
	models.

This kit provides for the installation of a Tubular Stainless Steel handle on a 3/4″ thick decorator door panel. The door extrusions allow the custom handle to be secured to the door structure, rather than to the custom panel.

•Select the extrusion for your model, discard other extrusion.

Tools and materials required:

•#2 Phillips screwdriver

•Drill and 1/8″, 9/32″ bits

•Custom door panel

•Safety glasses

•Center punch

•Masking tape

•Hammer

•Pencil

Parts List:

A. Handle extrusion (for left hand models) B. Handle extrusion (for right hand models) C. Stainless tubular handle

D. 4 Handle standoffs

E. 6 Screws for handle standoffs (4 required, 2 extra)

F. 6 Set screws (4 required, 2 extra) G. 3/32″ Allen wrench for set screws

This kit must be used in combination with ZKTR36RH or ZKTR36LH trim kit.

NOTE: It is best that 2 people install this kit.

A

B

C

D

E

F

G

Before you	• The 3/4″ custom panel must be routed to
begin:	accommodate the handle extrusion. Rout the panel
	as illustrated, 1/4″ deep, and 1-13/16″wide, top to
	bottom on the handle side.
	• Follow the instructions in the ZKTR36RH
	(or ZKTR36LH) to install trim onto the door.
	Discard the handle supplied with that kit.
	• Continue the instructions in the ZKTR36RH
	(or ZKTR36LH) trim kit to install support brackets
	to the bottom of the panel.

Custom Panel

1-13/16"

1/4" Max. Back Side

Handle Side

IMPORTANT: Optional final appearance depends on careful routing depth. Do not exceed 1/4″ routing depth.

33