Kathrein UFD 345 Receiver operation, Switching the unit on, Switching between TV and radio mode

Receiver operation

In this chapter you learn how to select TV and radio programmes using your re- ceiver, and how to adjust the volume and set up other functions.

Switching the unit on

∙Once the supply voltage is connected the unit goes into standby mode.

∙The key on the remote control is used to switch between standby and normal operation. Operation is shown by means of a red LED indicator in the infrared sensor.

∙The last programme slot selected is tuned in (last-status memory).

Switching between TV and radio mode

	Your receiver allows you to receive TV programmes or radio programmes.
	After switching on, the receiver is in either the TV mode or the radio mode (de-
	pending on the mode when switched off).).
	In TV mode, the programme slot indicator in the on-screen display (OSD) begins
	with "P". In radio mode, the screen is blanked out and the on-screen display begins
	with "R..“.
	∙ Press the	key on the remote control handset to switch between TV- and
	radio mode.
Note	In the initial setup menu, a continuous on-screen display of the radio programme
	slot can be selected independent of the TV setting (see section: “Initial settings, On
	Screen Displays “).

Selecting a programme

∙Use the numeric keys ... to select the desired programme directly. Example for a three-digit entry (with setting “free programme selection”): Selection of programme slot 147

∙1 is entered, programme slot 1 appears

∙4 is entered, programme slot 14 appears

∙7 is entered, programme slot 147 now appears.

or

∙Use the keys to step through the programmes in succession.

After the programme changeover, the programme slot and programme name are superimposed on the screen for approximately three seconds.

10