Kathrein UFD 345 manual OSD language, LNB supply voltage in standby, Programme selection

Initial settings

OSD language

Here you can select the language for the on-screen displays. The choice available comprises: German and English and French.

Default: German

LNB supply voltage

Here you can turn off the power supply for the feed system if this is implemented by an external power supply and signal selection is likewise not carried out by means of the LNB supply voltage (e.g. Kathrein single-cable feed system UAS 330).

Default: ON

LNB supply voltage in standby

When the receiver is in standby the LNB supply voltage is normally switched off. If terrestrial signals and satellite signals are combined in the receiving system, and the power supply for the relevant components comes from the receiver, the power supply must also be guaranteed when the receiver is in standby.

In this case switch the power supply in standby to “On“.

Default: “Off”.

Programme selection

You have the option of entering the programme number in one-, two-, or three-digit form or in “free” form (Default: “free”).

Setting	Settable programme slots
One-digit input	Programme slots 1 to 9
Two-digit input	Programme slots 1 to 99
Three-digit input	Programme slots 1 to 200
Free input	Programme slots 1 to 200

On Screen Displays (OSD)

Here you can select whether the programme slot and programme name are to be displayed continuously, or whether they are to be removed again approximately three seconds after programme changeover..

This setting can be made differently in TV mode and radio mode.

Default:	TV mode	“Off”.
	Radio mode	“On”.

To call the initial setup menu for radio, the receiver must be switched into radio mode before being switched off. Then call the initial setup menu in the usual way.

21