Command of the remote control
| The remote control features 2 command sets, making it possible to operate |
| 2 receivers independently of each other in one room (not together with a twin |
| receiver). |
Note | For this purpose, program one receiver on the command set 1 and the second |
| receiver on the command set 2. |
| Switch on receiver 1 and receiver 2 off with the power switch |
| Press and hold the button. |
| Enter "901" with the number buttons. |
| To adopt the code, press the button to switch receiver 1 to standby and |
| then switch off the device with the power switch. |
| Switch on receiver 2. |
| Press and hold the button. |
| Enter "902" with the number buttons. |
| To adopt the code, press the button to switch receiver 2 to standby and |
| then back into operation. Now switch on receiver 1 again. |
| Press and hold the button. |
Note | Enter "903" with the number buttons. |
When carrying out the first two settings, the remote control must be directed at the | |
| respective receiver (when switched on). |
| By pressing the button, you can now switch between the two command sets A |
| and B (toggle function) and alternately operate both receivers. |
| Command set 1 is always active as the |
Note | If you are operating only one receiver and the active command set is switched over |
| by mistake so that this receiver can no longer be operated, the remote control can |
| be easily switched back to command set 1. For this purpose, follow the procedure |
| described above. |
11
