Password
DiSEqC setting
The precondition for this setting is that you have made no changes in the DiSEqC (UFO)
When you are in the LNB configuration menu (see above), press the buttons to move the coloured bar to the "HotBird" position, press the or button
and by pressing confirm that you wish to add a satellite. The transponder data are now stored and a check appears after "HotBird" to confirm the setting. You can now set the DiSEqC signal. It serves the purpose of switching between the two
aligned satellites. Press the buttons to go to the
Set #1 for ASTRA and #2 for HotBird. Both positions are already
Press the button 4 times to exit the menu. At the same time, the receiver will confirm that the set parameters have been saved. If a setting is incorrect, you will see this message on the screen:
bad or no signal
With cascaded switches, a total of 16 satellite positions can be stored under DiS- EqC 2. With H/V as well as High/Low this results in a total of 256 settings. You should have a specialist carry out these settings and
Antenna settings
This menu is intended solely for service purposes and, if need be, i.e. if no measuring instrument is available, it can be used to align the antenna (satellite dish).
The satellite can be defined in the first line and the transponder in the second.
The polarisation of the received signal and the transmitted symbol rate are shown in the next line.
The bar displays provide an indication of the strength (relative level) of the signal and its quality. However, no conclusions relating to the quality of the antenna sys- tem or of the cable connection can be derived from this signal.
Satellite search
In the satellite search menu, you can search for programmes on one satellite
from a receiver . With the or button
select the satellite. Press the button to start the search.
If you wish to set your system to a completely new satellite, you will need to manually enter at least one known transponder in order to start the search
(see Section "TP
39
