Althoughthedirtsensorfeaturein your KenmorePoweFMateisdesignedforyearsof troublefreeuse,thepassageof dirtthrough theairpassagesystemcancoatthelens causingthegreenlighttocomeonandstay
on - neverswitchingto red.Whenthishappens thelensesmustbe cleaned,
CAuTiON
Never use water or any cleaning solution
when cleaning the lenses, The residue of the water or cleaners will accelerate the
recoating of the lenses and make
cleaning necessary sooner.
TO CLEAN THE LENSES
1. Remove the wand by pressing the quick release pedal and lifting up on the wand°
3 ½ Inches | ,,,,/. | Ring |
or 90 mm | lt | Jz_l, _ |
2, As indicated by the illustration, the two dirt sensor elements are boated on the inside of
the swivel, approximately 3Ya inches/90 mm down, (note the arrows) Each element should
be cleaned periodically, To reach the sensor elements, use a small brush such as a botlle brush° Brush each sensor element several times to remove dust and dirt,
NOTE: Looking down inside the swivel you will see a ring. The sensor elements are located just slightly below this ring.
3.Reinstall the wand after cleaning the sen- sors,
TO REMOVE BELT
1. Turn Power-
Mate ® upside down.
2. Unscrew the
two (2) Power- Mate e cover
screws_
3.Turn Power- Mate ® right side up. Press handle release pedal and lower the swivel, Lift rear latches
up,
Latch Latches
4. To remove cover, grasp the sides and pull out.
5.Lift agitator assembly out and remove worn bell
6, Check and clean end cap areas, See AGITATOR ASSEMBLY for picture of complete agitator assembly
18
