Kenmore 116.25812 Hood And Tool Storage Cover, kCAUTION, Hose, To Install, To Remove, Canister

CANISTER

1.Open the canister hood

2.Check to see that the dust bag is proper- lyinstalled. See BAG CHANGING for instructions.

3.Check to see that the motor safety filter is properly installed, See MOTOR SAFETY FILTER CHANGING for instructions

HOOD AND TOOL

STORAGE COVER

It is normal for the canister hood and tool storage cover to come off when opened fur- ther than needed. Line up the hinge slots, insert the hinges into the slots, and close the hood and toot storage cover to reinstall,,

i

kCAUTION

Never open canister hood with the tool storage cover open. This will help to prevent damage from occurring to the canister hood and/or toot storage cover.

HOSE

1.Line up the hose latch tab and notch in canister hood and insert hose

into canister until it Hose

snaps	in place		Latch
			Tab
To remove:		Lift
hose latch tab			Notch
upward	and	pull	up
on hose,

	2.	Insert			handle
	into		wand		until
	lock		button
	snaps			in place,
Lock	Be		sure		hose
	is	not		twisted,
m
=a	To remove:
Handle
Quick	Press			handle
Release_,,.,._	quick			release
	button			and pull
	up	on		handle,

To store: Disconnect hose from wands and canister to prevent stress on hose during storage, Store hose in a loosely coiled

position so the hose covering is not stressed,

This canister is equipped with an on-board storage area for a Power-Mate ,Jr, e attachment°

To Install:

Open the Power-Mate Jr2 storage cover, insert the Power-Mate Jr,e, press down into place, and close the lid securely,

To Remove:

Open the storage cover. Remove Power- Mate Jr.® from the storage area and use as needed (see ATTACHMENTS and

ATTACHMENT USE TABLE).

Power-Mate Jr, ®

Storage Cover

/