Kenmore 116.28015, 116.28014 owner manual To Clean Agitator, Agitator Assembly, To Replace Belt

TO CLEAN AGITATOR:

NOTE: In order to keep cIeaning efficiency high and to prevent damage to your vacuum

cleaner, _must be cleaned every time the belt is changed.

The agitator must also be cleaned accord- ing to the following schedule:

Vacuum Cleaner Use Clean Agitator

HEAVY -	every week
(used daily)
MODERATE -	every	month
(used 2-3 times/week)
LIGHT	every	2 months
(used 1 time/week)

IMPORTANT

Turn off and unplug vacuum cleaner from electrical outlet. Check and remove hair,

string and lint build-up frequently in the PowerMate agitator and end cap areas.

Remove any dirt or debris in the belt path area or in the brush roller area,

Carefully remove any string or debris located on the agitator or end caps°

AGITATOR ASSEMBLY

Belt Path

2. Place agitator assembly back into PowerMate.

3. Reinstall

agitator cover and

replace two

(2) screws.

4.Line up front of cover and base° Rest cover on front edge of base as shown,

5.Rotate cover back, Press

cover firmly until side latches

snap into place°

Make sure there is no gap between the cover and base°

6, Turn PowerMate upside down and replace five (5) cover screws,

7, Insert floor

_ End Cap

Brush Unit

End Cap _

brush into PowerMate until floor brush locks into place.

TO REPLACE BELT

1, Install new belt over

motor drive, then over

belt path,

\ Path

Agitator End Cap

NOTE: See PARTS AND FEATURES for Belt number.

20