Toselecta pile heightsetting:
Turnoffvacuumcleaner. Select a pile height setting by tilting the vacuum cleaner back until front wheels are lifted slightly off the floor.
Slide the adjustment lever to the correct setting.
There are tour (4) pile height settings on the vacuum cleaner. Use the LOW setting for most
CAUTION
Do not allow vacuum cleaner to remain in one spot for any length of time when the agitator is turn- ing. Damage to carpet may occur.
SOME MODELS
Bare floor setting: Slide the carpet/bare
floor selector all the way back and down toward the bottom of the nozzle until it
locks into place.
In this position the brush assembly does not revolve. This setting should be used for cleaning hardwood and tile floors and
when any attachments (tools) are used.
Carpet setting: Slide the selector all the way forward and up to the carpet position.
In this position the brush assembly will turn. When carpets are being cleaned the selector should be in this position.
Attention: Refer to your carpet manufac-
turers cleaning recommendations. Some more delicate carpets may require that they be vacuumed with the agitator turned off, to prevent carpet damage.
!CAUTION
Do not allow vacuum cleaner to remain in one spot for any length of time when the agitator is turn- ing. Damage to carpet may occur.
Note: For longer belt life, turn the vacuum cleaner off before moving selector, other- wise make sure the selector is pushed fully and quickly as possible to the
desired position. Failure to do so can cause the belt to rub on the selector shaft
and may result in the belt becoming hot and creating a burning rubber smell.
Carpet/Bare
Floor Selector
To Carpet
Position
To Bare Floor
Position
7