Kenmore 153.32686, 153.326761, 153.326561, 153.326361, 153.326461, 153.326661 Safety Precautions

Safety Precautions

_,WARNINGJ

Improper installation, adjustment, alteration, service or maintenancecan cause DEATH, SERIOUS BODILY INJURY,J

OR PROPERTY DAMAGE. Refer to this manual for assis- tance or consult your localSearsService Center for further information.

_WARNING

At the time of manufacture this water heater was provided with a combination temperature*pressures relief valve certi- fied by a nationally recognized testing laboratory that main- tains periodic inspection of production of listed equipment or materials, as meeting the requirements for Relief Valves and

Automatic Gas Shutoff Devices for Hot Water Supply Systems, and the current edition of ANSI Z21.22 • CSA 4.4 and the code requirements of ASME. If replaced, the valve must meet the requirements of local codes, but not lessthan a combination temperature and pressure relief valve certified as meeting the requirements for Relief Valves and Automatic

Gas Shutoff Devices for Hot Water Supply Systems, ANSI Z21.22 • CSA 4.4 by a nationally recognized testing laboratory that maintains periodic inspection of production of listed equipment or materials.

The valve must be marked with a maximum set pressure not to exceed the marked hydrostatic working pressure of the water heater (150 Ibs. p.s.i.) and a discharge capacity not less than the water heater input rate as shown on the model rating plate. (Electric heaters - watts divided by 1000 x 3412 equal

BTU/Hr. rate.)

Your local jurisdictional authority, while mandating the use of

a temperature-pressure relief valve complying with ANSI

Z21.22 • CSA 4.4 and ASME, may require a valve model differ- ent from the one furnished with the water heater.

Compliance with such local requirements must be satisfied by the installer or end user of the water heater with a locally wescribed temperature-pressure relief valve installed in the

designated opening in the water heater in place of the factory furnished valve.

For safe operation of the water heater, the relief valve must not be removed from it'sdesignated opening or plugged.

The temperature-pressure relief valve must be installed directly into the fitting of the water heater designated for the relief valve. Position the valve downward and provide tubing so that any discharge will exit only within 6 inches above, or at any distance below the structural floor. Be certain that no con- tact is made with any live electrical part. The discharge open- ing must not be blocked or reduced in size under any circum- stances. Excessive length, over 30 feet, or use of more than four elbows can cause restriction and reduce the discharge capacity of the valve.

No valve or other obstruction is to be placed between the relief valve and the tank. Do not connect tubing directly to dis- charge drain unlessa 6" air gap is provided. To prevent bodily injury, hazard to life, or property damage, the relief valve must be allowed to discharge water in quantities should circum- stances demand. If the discharge pipe is not connected to a drain or other suitable means, the water flow may cause prep- erty damage.

The Discharge Pipe:

• Must not be smaller in size than the outlet pipe size of the valve, or haveany reducing couplingsor other restrictions.

• Must not be plugged or blocked.

• Must be of material listed for hot water distribution.

• Must be installed so as to allow complete drainage of both the temperature-pressure relief valve, and the discharge pipe.

• Must terminate at an adequate drain.

• Must not have any valve between the relief valve and tank.

2

_,WARNINGJ

HAZARD OF ELECTRICAL SHOCK! Before removing any access panels or servicing the water heater, make J sure the electrical supply to the water heater is turned "OFF". Failure to do this could result in DEATH, SERI-

OUS BOD LY NJURY,OR PROPERTY DAMAGE.

AWARNING

HOTTER WATER CAN SCALD: Water heaters are intended to produce hot water. Water heated to a tem- perature which will satisfyspaceheating, clothes washing, dish washing, and other sanitizing needs can scald and _ermanently injure you upon contact. Some people are

more likely to be permanently injured by hot water than others. These include the elderly, children, the infirm, or physically/mentally handicapped. If anyone using hot water in your home fits into one of these groups or if

there is a local code or state law requiring a certain tem- perature water at the hot water tap, then you must take special precautions. In addition to using the lowest possi- ble temperature setting that satisfies your hot water needs, a means such as a mixing valve, shall be used at

the hot water taps used by these people or at the water heater. Mixing valves are available at plumbing supply or hardware stores. Follow manufacturers instructions for

installation of the valves. Before changingthe factory set-

ting on the thermostat, read the "Temperature

Regulation"section in this manual.

&WARNING

WATER HEATERS EQUIPPED FOR ONE VOLTAGE ONLY: This water heater is equipped for one type voltage only. Check the rating plate near the bottom access panel for the correct voltage. DO NOT use this water heater with any voltage other than the one shown on the model rating plate. Failure to use the correct voltage can cause problems which can result in DEATH, SERIOUS BODILY

INJURY, OR PROPERTY DAMAGE. If you have any ques- tions or doubts consult your electric company.

&WARNING

INSULATING JACKETS: When installing an external water heater insulation jacket on an electric water heater:

a. DO NOT cover the temperature-pressure relief valve. b. DO NOT put insulation over the access covers or any access areas.

c. DO NOT remove operating instructions, and safety

related warning labels and materials affixed to the water heater.

d. DO obtain new warning and instruction labels from

Sears for placement on the jacket directly over the exist- in_ labels.

_,WARNINGJ

Do not usethis appliance if any part of it has been under J water. An electrical short or malfunction could occur.The

water heater shoud be rep aced.

CAUTION

WATER HEATERS EVENTUALLY LEAK: Installation of

the water heater must be accomplished in such a manner that if the tank or any connections should leak, the flow of water will not cause damage to the structure. When such locations cannot be avoided, a suitable drain pan should be installed under the water heater. Drain pans are avail- able at your local Sears Store. Such a drain pan must be piped to an adequate drain.