Installation Instructions (cont'd)
Water Piping
AWARNING
HOTTERWATER CAN SCALD:.Water heatersam intendedto
producehot water. Water _ to a temperaturewhichwill sat_fyclotheswashing,dishwashing,andother sanitizingneeds
canscaldand permanentlyinjureyou uponcontact.Some
Etsintooneofthesegroupsor ifthere isa localcodeor stateI_v reclulrlnga certaintemperature water at the hot water_ then youmusttake specialprecaution_In additionto usingthe lowest possibletemperaturesettingthat satisfiesyour hot water needs, a meanssuchasa mixingvalve,shouldbe usedat the hotwater tapsusedby thesepeopleor at the water heater.Mixingvalves
areavailableat plumbingsupplyor hardwarestore_ Followman. ufacturers instructionsfor installationof the valves.Before
changingthe factory setting on the thermostat, read the "Temperature Regulation"sectioninthis manual.
•Look at the top cover of the water heater. The cold water inlet is
ble connectors, connect the cold water pipe to the coldwater inlet of the water heater.
NOTE: This water heater is super insulated to minimize heat loss from the tank. Further reductmn in heat loss
can be accomplished by insulating the hot water lines from the water heater.
INSTALLATION COMPLETED USING
"SEARS INSTALLATION KIT
HOT | OUTLET | FLEXIBLE WATER | COLD | INLET |
TO | HOUSE | CONNECTORS | WATER | LINE |
This water heater shall not be connected to any heating systems or component(s) used with a
If a water heater is installed in a closed water supply system; such as one having a
local utility or local Sears Service Center on how to control this situation,
NOTE: To _protect against untimely corrosion of hot and cold water fittings, it is strongly recommended that
tric unions or couplings be installed on this water heater when connected to copper pipe.
The illustration shows the attachment of the water piping to the
water heater. The water heater is equipped with ¾" water con- nections.
NOTE: If using copper tubing, solder tubing to an adapter before attaching the adapter to the cold water inlet connec- tion. Do not solder the cold water supply line directly to the
cold water inlet. It will harm the dip tube and damage the tank.
•Look at the top cover of the water heater. The water outlet is marked hot. Put two or three turns of teflon tape around the
threaded end of the
both ends of the _A" threaded nipple. Using flexible connec- tors, connect the hot water pipe to the hot water outlet on the water heater.
Ilg3
THREADED TO SWEAT COUPLING
THREADED TO
SWEAT COUPLING
HEAT TRAP WITH |
| IolA | _ | 314" THREADED |
SECONDARY | _ | I | ] _ | HEAT TRAp |
ANODE |
|
|
|
|
PRESSURE
RELIEF VALVE
DISCHARGE PIPE (Do not cap or plug)
FLOOR DRAIN
11