Fujitsu ST5111, ST5112 manual Removing a Memory Module, Installing a Dimm Module

3.Insert the DIMM module in the socket at an angle and push it down until it locks into place as shown in Figure 2-9. Note that the DIMM module is keyed to prevent it from being inserted backwards.

U s i n g Y o u r S t y l i s t i c S T 5 1 0 0

Removing a Memory Module

To remove a DIMM module:

1.Ensure that the Tablet PC is off. To do so, carry out the Shut Down command in the Start menu. (Do not attempt to remove or install a DIMM module when the system is in Standby mode or running.)

2.Remove the screws from the cover plate on the back of the Tablet PC and remove the cover plate as shown in Figure 2-8.

3.Spread the fingers on the socket that lock the DIMM module in place until the DIMM module is loose.

Figure 2-9. Installing a DIMM Module

4.Reinstall the cover and screws that you removed in step 2.

5.Confirm that the DIMM module is recognized by the system. To do so, run BIOS Setup. The size of the DIMM module should be displayed in the Info menu in BIOS Setup.

The DIMM module is installed in the Tablet PC and you can now use the system.

Figure 2-10. Removing a DIMM Module

4. Remove the DIMM module from the socket.

The DIMM module is now removed from the Tablet PC. See "Installing a Memory Module" to install a new DIMM module.

35