Fujitsu ST5112, ST5111 manual System Status Indicators

S t y l i s t i c S T 5 1 0 0 S e r i e s T a b l e t P C U s e r ’ s G u i d e – S e c t i o n O n e

In the following table, a “blinking” LED flashes at the rate of once per second; an LED that is “blinking, slow” flashes at the rate of one second on, five seconds off.

	Icon	Mode/State		LED State	Remarks
	Battery	• On State		Green, continuous	Battery charge is between 50%-100%
		• Idle Mode		Amber, continuous	Battery charge is between 13%-49%
				Red, continuous	Battery charge is between 0%-12%
				Red, blinking	There is a battery error.
		• Standby,		Green, blinking slow	Battery charge is between 50%-100%.
		without AC
				Amber, blinking slow	Battery charge is between 13%-49%.
		adapter
		• Standby with AC		Red, blinking slow	Battery charge is between 0%-12%.
		adapter
		• Hibernate,		Off	Battery is not installed, or system is off or in
		with AC adapter			Hibernate mode.
		• Off State
		• Hibernate,			If battery is inserted during power off, LED
		without AC			blinks amber for 4 seconds to detect
		adapter			battery. Battery status is displayed for 5
					seconds after that.
HDD Access		• On State (or		Green	Displayed when hard disk drive is accessed.
		flashing)
		• Idle Mode
		• Standby		Off	Hard disk drive is not being accessed.
		• Hibernate
		• Off State
	Security	• On State		Green, continuous	The Security Indicator lights (if a password
				(until password is	was set) when the system resumes from
				entered)	Off or Standby modes. You must enter the
					password that was set in the Security Panel
					before your system will resume operation.
					(See Security Functions of Application Buttons
					on page 17 for more information.)
			Table 1-1. System Status Indicators

12