USING THE SHOCK SENSOR UTILITY
The Shock Sensor Utility is designed to decrease the risk of damage to the computer's hard disk drive (HDD) in the event of excessive impact or vibration. The Shock Sensor Utility also has the ability to improve the security of the computer by automatically locking the computer with a password when it is carried. Note that the HDD protection and computer locking features are mutually exclusive; both cannot be selected at the same time.
■Shock Sensor Utility does not completely protect the HDD and does not provide absolute security for the computer.
■The computer may stop temporarily while the HDD head is retracted. To restart the computer, keep the system horizontal.
1.
2.Click the red [Setting] button. The [Shock Sensor Utility Settings] window appears.
Action
Select the action you wish this utility to perform:
■Protect HDD from impact. HDD head is retracted when an impact to the computer is detected.
■Lock computer when carried. Lock the computer when it is being carried.
■Nothing. No action.
Sensitivity of impact/horizontal move/fall/carry detection
Adjust the sensitivity of the acceleration sensor based on system motion or impact.
Ignore periodic vibration.
If vibration is periodic, disregard it.
Ignore mouse click
When the mouse is clicked, sensitivity is temporarily lowered.
Ignore keyboard action
When the keyboard is used, sensitivity is temporarily lowered.
Confirm calibration when user logs on
Select [Confirm calibration when user logs on] if you want to recognize the current orientation as horizontal at logon.
Perform calibration automatically when user logs on
Select [Perform calibration automatically when user logs on] if the system is normally used on a horizontal surface.
U s i n g Y o u r S t y l i s t i c S T 5 1 0 0
[Calibrate Now]
The calibration is executed. Please position the computer as horizontally as possible, then click the [Calibrate Now] button. The current horizontal position will be recog- nized as the true horizontal by performing the calibra- tion.
3.Click the [OK] or [Cancel] button. The [Setup] window closes.
Using the Shock Sensor Monitor Window
Note that the Monitor is designed for entertainment, and has no effect on system settings or orientation. To navi- gate the monitor, use the buttons described below.
■Advance. Incline the display to the hinge side, or use [Up] key.
■Back. Incline the display to the
■Right. Incline the display to the right side, or use [Right] key.
■Left. Incline the display to the left side, or use [Left] key.
■Go up. Use [A] key.
■Go down. Use [Z] key.
■Close. Use [Esc] key.
ADJUSTING THE DISPLAY BRIGHTNESS
There are four ways to adjust your display’s brightness:
Depending upon whether you are running your system on battery or AC power, the default screen brightness settings will be different. The screen brightness default for running on battery is lower than that on AC power in order to optimize battery life.
■Windows XP Tablet PC: Click the Tablet icon in the sys- tem tray at the bottom right of the screen. (When the cursor is on top of the icon, a message stating “Change tablet and pen settings” is displayed.) When the Tablet and Pen Settings window appears, select the Display tab, and move the Screen Brightness slider to change the brightness.
Windows Vista: Open the Windows Mobility Center control panel by
■Click Start
■Click the Fujitsu Menu icon in the system tray at the bottom right of the screen. (When the cursor is on top of the icon, a message stating “Fujitsu Menu...” is dis-
29
