Fujitsu ST5111, ST5112 manual Modem Connection, Memory STICK/SD Card Slot, PC Card Slot

Models: ST5112 ST5111

1 96
Download 96 pages 20.54 Kb
Page 41
Image 41

MODEM CONNECTION

The internal 56 Kbps LAN/modem module installed in the Stylistic ST5100 Series Tablet PC has actual maximum transfer rates of 53 Kbps (receive), 33.6 Kbps (send), and 14.4 Kbps (fax). Download rates are limited to 53 Kbps in the United States due to FCC restrictions.

The Stylistic ST5100 Series Tablet PC is designed to accept a standard RJ-11 telephone plug. Connect the plug to the modem jack located on the left-hand side of the Tablet PC (See Figure 1-5 on page 9 for location). The tele- phone plug can be inserted whether or not the Tablet PC has power applied.

If you need assistance configuring the Stylistic ST5100 Series Tablet PC modem or LAN, contact your local help desk or reseller.

MEMORY STICK/SD CARD SLOT

Your Tablet PC supports Memory Stick and SD flash memory cards on which you can store and transfer data to and from a variety of digital devices. These cards use flash memory architecture, which means they don’t need a power source to retain data.

Memory Stick is a flash memory technology developed by Sony Electronics. Memory Stick allows you to record, transfer and share digital content, such as digital pictures, movies, music, voice, and computer data and applica- tions.

Secure Digital (SD) Cards are very similar to Memory Sticks, but they are shorter. Like the Memory Stick, SD Cards allow portable storage among a variety of devices, such as cell phones, GPS systems, digital cameras, and PDAs. SD Cards transfer data quickly, with low battery consumption. Like the memory stick, it uses flash memory architecture.

Figure 2-5. Memory Stick and Secure Digital Card

U s i n g Y o u r S t y l i s t i c S T 5 1 0 0

Inserting Memory Stick/SD Cards

Memory Sticks and SD Cards are inserted in the Memory Stick/SD Card slot (Figure 1-4). To insert a Memory Stick or SD Card, follow these steps:

Inserting or removing a Memory Stick or SD Card during your system’s shutdown or bootup process may damage the card and/ or your computer.

Do not insert a card into a slot if there is water or any other substance on the card as you may permanently damage the card, your Tablet PC, or both.

1.See your Memory Stick or SD Card manual for instructions on the insertion of your card. Some cards may require that your system is off while inserting them.

2.Make sure there is no card currently in the slot. If there is, see Removing a Memory Stick/SD Card.

3.Insert your card into the slot with the product label facing up.

4.Push the card firmly into the slot until it is seated in the connector.

Removing A Memory Stick/SD Card

To remove a Memory Stick/SD Card, follow these steps:

See your Memory Stick or SD Card manual for specific instructions on the removal of your card. Some cards may require your computer to be in Standby Mode or Off while removing them.

Push the Memory Stick or SD Card in until it unlatches. It will then eject from the slot for removal

PC CARD SLOT

The Stylistic ST5100 Series Tablet PC Card slot allows you to insert a Type I or Type II PCMCIA Card.

Inserting a PC Card

To insert a PC card, position the side with the arrow facing up (i.e., when looking at the tablet’s display side, the arrow on the card should be visible.) Slide the card into the PC Card slot, and press it firmly to ensure proper seating. (See Figure 2-6 for location)

If you need assistance inserting a PC Card in the Stylistic ST5100 Series Tablet PC, contact your corporate help desk or reseller.

33

Page 41
Image 41
Fujitsu ST5111, ST5112 manual Modem Connection, Memory STICK/SD Card Slot, PC Card Slot