CALIBRATING THE PEN
In order to ensure accurate tracking between the pen and cursor, you must run the Touch Screen Calibration Utility before you use the active digitizer for the first time, or after you change the display resolution.
To run the calibration utility:
1.Go to Start
2.Click Calibrate.
3.Adjust the display of your Tablet PC to a comfortable angle.
4.Using the pen, firmly touch the screen directly on the (+) symbol; the (+) symbol will move to the next location.
5.Repeat step 4 in the four corners, then click OK.
INSTALLING A PEN TETHER
To prevent dropping or losing your pen, you should attach it to your system using the pen tether that is included with the system.
To attach the pen tether to your Tablet PC, perform the following steps:
1.Attach the end of the pen tether with the smaller loop to your pen. Do do so, push the end of the tether through the hole in the pen, then thread the opposite end of the tether through the loop. (See Figure
Pen tether attachment point
Larger loop
Smaller loop
Figure 2-2. Installing a Pen Tether
2.Attach the end of the pen tether with the larger loop to the attachment point on your pen tablet. To do so, insert the end of the pen tether through the attach- ment point, then feed the pen through the large loop in the tether.
REPLACING THE PEN TIP
With use, the pen tip may become worn or may pick up foreign particles that can scratch the screen. A damaged or worn tip may not move freely, causing unpredictable results when using the pen. If your pen exhibits these problems, you should replace the pen tip. To do so, use the pen tip removal tool included with your pen.
U s i n g Y o u r S t y l i s t i c S T 5 1 0 0
Gap
Figure 2-3. Tip Removal Tool
To remove the tip, position the tip in the gap between the two ends of the tool. Pinch the tool together so the tip is firmly clasped, then pull it from the barrel. If the tip is worn or damaged, discard it.
To replace the tip, retrieve one of the new tips that accom- panied your pen. Insert the flat end of the tip into the barrel and push it in firmly until it is seated.
If you need more tips, they can be ordered from the Fujitsu website at: us.fujitsu.com/computers.
CHARGING THE BATTERY
The Stylistic ST5100 Series battery can be charged while it is installed in the Tablet PC.
To charge the battery:
1.Connect a DC power source, such as the AC adapter, to the DC input connector on the Tablet PC. The DC Input icon appears in the Status display. If the battery charge is below 90%, the battery begins charging and the Charging icon appears in the Status display. If the battery charge is 90% or higher when you connect DC power, the battery will not charge, preventing battery overcharging.
2.Look at the Battery Charge icon in the Status display to determine the percent of charge in the battery. See “Status Display” in Chapter 1 of this manual for a description of the Battery Charge icon.
As long as DC power remains connected to the Tablet PC, the charging process continues until the battery charge reaches 100%.
Also note the following with respect to charging the battery:
•You can use the system, suspend system operation, or shut down and turn off the system without interrupting the charging process; however, using the system while the battery is charging will cause the battery to charge at a slower rate.
•As noted in the procedure above, the system will not begin charging the battery if the battery charge level is 90% or higher when the system is initially connected to external DC power. (This prevents the battery from being overcharged.)
31
