Kenmore 385.160201 owner manual Changing

Changing	Needle				S
(_ Needle clamp screw						Fiat	side
(_ Needle	clamp					Lado	piano ._	N dl
[] Turn off the power switch.
						M6plat vers		Aguja
Raise the needle to its highest position by turning the
handwheet	counterclockwise,		toward you, and lowering					Ague
the presser foot. Loosen the needle clamp screw(_0by					[]			[]
turning it counterclockwise.			Remove the needle	from the
needle clamp _).
[] Insert a new needle into the needle clamp_with				the
flat side to the rear. When inserting the needle into the
needle clamp (_, push it up as far as it goes. Tighten
the needle clamp screw (_0firmly by turning it clockwise.
[] To see if the needle is good, place the fiat side of the
needle onto something flat (needle plate, glass, etc.).
The gap between the		needle and the fiat surface should				[]
be consistent. Never		use a bent or blunt needle.

A damaged needle can cause permanent snags or runs in knits, fine silks and silk-like fabrics.

J

To Remove and Attach the Foot Holder _0 Thumb screw

Foot holder

Presser bar

• TO remove

Remove the thumb screw (_0by turning it counterclockwise with a screwdriver.

• To attach

Match the hole in the foot holder(_with the threaded hole in the presser bar _). Fit the thumb screw (_0into

the hole. Tighten the screw(_0by turning it clockwise with a screwdriver.

			J
Changing	Presser	Foot
_0 Snap-on button (red button)
Groove
_Pin
• TO remove
Raise the needle to its highest position by turning the
handwheet counterclockwise. Raise the presser foot, and
press the red button(_0 on the back of the foot holder.
• To attach			.!.
Place the selected		presser foot, so that the ping on the

foot lies just under the groove (_ on the foot holder. Lower the presser bar to lock the foot in to the place.

J

10