Kenmore 5303304549 Anti-Tip Brackets Installation Instructions, If the Range is Ever Moved to a

Anti-Tip Brackets Installation Instructions

Important Safety Warning

To reduce the risk of tipping of the range, the range must be secured to the floor by properly installed anti-tip brackets and screws packed with the range Failure to installthe anti-tip bracketscould allow the range to accidentally tip over ff excessive weight is placed on an open door or if a child climbs upon it. Serious injury might resultfrom spilled hot liquids or from the range itselL Referto the instructions below for proper installation

_+r_mP BP_o_r

!

ANt3.'_'P

BRAO<ET

IF THE RANGE IS EVER MOVED TO A

DIFFERENTLOCATION, the anti-tip brackets must atso be moved and

installed with the range°

Tools+Required:

5/! 6" Nutddver or Flat Head Screwdriver

Adjustable Wrench

Electric Drill & 3/16" Diameter Drill Bit 3/16" Diameter Masonry Ddll Bit

:(if installing in concrete)

Figure 1: Leveling Leg Instructions

Anti+Tip Brackets Installation Instructions

The brackets attach to the floor at the back of the range to hold both rear leg levelers,,When fastening to the floor, be sure that the screws do not penetrate electrical Wiring or plumbing.. The screws provided will work in either wood or concrete°

i., Unfold the paper template and place it flat on the floor with the back and side edges positioned exactlywhere the back and sidesof rangewill be locatedwhen installed,Use the illustrationabove to locate the brackets if a template is not available,,

2.Mark on the floor the location of the four mounting holes shown on the template° Foreasierinstallation, 3/16" diameter pilot holes, a t/2" deep can be drilled into the floor_

3.Remove the template and place the brackets on the floor with the turned-up flange to the front,, Lineup the holes in the brackets with the marks on the floor and attach with the screws provided,, The brackets must be secured to a solid floor° tf attaching to a concrete floor, first drill 3/16" diameter pilot holes using

a masonry drill bit.

4., Levelthe range ff necessaryby adjusting the four leg levelerswith awrench See Figure 1, side box. A minimum clearance of 1/8" is required between the bottom of the range and the rear leveling feet.

5.Slidethe range into place making sure the rear legsare trapped bythe ends of the brackets. The range may needto be shifted slightly to one side as it is being pushed backto allowthe rear legsto align with the brackets Remove the lower panel or storage drawer to inspect the brackets, or grasp the top rear edge of the range and carefully attempt to tilt it forward to make sure the range is properly anchored.

16