Setting Surface Controls (cont'd)

Operating the Dual Surface Element

The cooktop is equipped with two Dual radiant surface elements located at the right and left front cooktop position (Figure 1). indicator lights on the control panel at that position are used to indicate what portions of the Dual radiant element will heat. The INNER light indicates that only the inner element will heat (Figure 2). The OUTER light indicates that

both inner and outer elements will heat together (Figure 3).Figure 1 You may switch between these different settings at any time

during cooking.

To Operate the Dual Surface Element:

1.Place correctly sized cookware on the radiant surface element.

OUTER

_ INNER

Figure 2

_ OUTER

_ INNER

Figure 3

.

Touch and hold the, pad for the Dual element position until a beep is

heard. The display will show" - - ". Note: If no further pads are touched within 10 seconds the request to power the element ON will clear.

3.Select the INNER (Figure 2) or OUTER (both elements) (Figure 3) to heat by

ELEME_"_T

pressing the _ pad once or twice times (Figures 3 & 4 show indicator

lights with OUTER selected). Note: If no element size is chosen when the dual element is turned ON, the control will default to the inner coil only.

4. Touch HI _ pad once to turn ON the power level to HI. Touch Lo

pad once for Lo (See Figure 4).

HI

OUTER ;;............

(,£i:ii

........ii

Lo(V hINNER

5.

Each touch of the HI _

or Lo _

pad will increase or decrease power

 

levels from 9.5 through 3.0 by .5 increments. Simmer power levels between 3.0

 

and 1.2 will decrease or increase by .2 increments.

Lo is the lowest power

ElEMEnT

 

level available.

 

 

 

S IZE

 

 

 

 

 

 

Note: The power level may be adjusted at any time while the element is ON.

.

When cooking has been

completed

touch the

pad once to turn the

entire

Figure 4

element OFF.

Each dual surface element provides a constant amount of heat at each setting. The different glow of the 2 elements is normal and doesn't affect heating performance (See Figure 3). A glowing red surface heating area extending

beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area.

Note: If no element size is chosen when the dual element is turned ON, the control will default to the inner coil only. See page 9 for recommended surface cooking settings.

Note: The Hot Element message will remain displayed on the control panel as long as the element is still hot and will remain ON until the heating surface area has cooled sufficiently.

Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.

Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon homers or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Pothoiders, towels or wooden spoons could catch fire if placed too close to the surface elements.

11

Page 11
Image 11
Kenmore 790.4101 manual LoV hINNER, Operating the Dual Surface Element, To Operate the Dual Surface Element