Setting Surface Controls (cont'd)

Operating Single Radiant Surface Elements

The cooktop has 2 SINGLE radiant surface elements: the RIGHT REAR position (Figure 1) and the LEFT REAR position (Figure 2).

To Operate the Single Radiant Surface Elements:

1.Place correctly sized cookware on the radiant surface element.

.

Touch and

hold the q

pad for the desired element position until a beep

is heard.

 

Figure 1

Right Rear Element

 

 

 

 

 

 

 

 

The display will show " -- "

 

 

 

 

 

 

 

 

Note: If no further pads are touched within 10 seconds the request to power the

 

 

 

 

element ON will clear,

 

 

 

 

 

 

 

.

Touch HI _

pad once to turn ON the power

level to HI. Touch Lo _'_)

pad

 

 

 

 

 

 

 

 

 

 

 

 

 

once for Lo (See Figure 3). The Not Surface indicator light will turn ON when the

(

)(

)

 

element becomes hot.

 

 

 

 

.

Each touch

of the Hi _

or Lo _

pad will decrease or increase the power

 

 

 

 

 

 

 

 

 

 

 

 

 

level from 9.0 through 3.0 by .5 increments. Simmer power levels between 3.0 and 1.2

 

Figure

2

 

Left

Rear Element

 

will decrease or increase by .2 increments, Lo is the lowest power level available,

 

 

 

 

 

Note: The power level may be adjusted at any time while the element is ON.

 

 

 

 

.

When cooking has been completed

touch the

pad once to turn the element

 

 

 

 

OFF.

 

 

 

 

 

 

 

 

Each surface element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area.

Note: The Hot Element message will remain displayed on the control panel as long as the element is still hot and will remain ON until the heating surface area has cooled sufficiently,

Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently,

Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements,

Figure 5

10

Page 10
Image 10
Kenmore 790.4101 manual Operating Single Radiant Surface Elements, To Operate the Single Radiant Surface Elements