Troubleshooting
Messages
Caractéristiques techniques
If you experience any problems with the unit, please take a moment to look through this chart and see if you can solve the problem yourself before you call your dealer or a TEAC service center.
No power
eCheck the connection to the AC power source. Check and make sure the AC source is not a switched outlet and if it is, the switch is turned on. Make sure there is power to the AC outlet by plugging another item such as a lamp or fan.
No sound.
eAdjust the volume.
The sound is noisy.
eThe unit is too close to a TV set or similar appliances. Relocate the unit further away from them, or turn the other appliances off.
Remote control doesn’t work.
ePress the STANDBY/ON button of the main unit to turn it ON.
eIf the battery is dead, change the battery.
eUse the remote control unit within the (5m) range and pointed at the front panel.
eClear obstacles that are between the remote control unit and the main unit.
eIf a strong light is near the unit, turn it off.
CD
Will not play.
eLoad a disc with the playback side facing down. eIf the disc is dirty, clean the surface of the disc.
eA blank disc has been loaded. Load a prerecorded disc.
eDepending on the disc, etc. it may not be possible to play back
Sound skips.
ePlace the unit on a stable surface to avoid vibration and shock.
eIf the disc is dirty, clean the surface of the disc. eDon’t use scratched, damaged or warped discs.
Tuner
Cannot listen to any station, or signal is too weak. eTune in the station properly.
eIf a TV is near the unit, turn it off.
eRotate the unit or antenna wire for the best reception position. In an area where the signal are weak, an outdoor FM antenna may be required.
Turntable
Will not play.
eLoosen the transportation screw, and remove the stylus guard.
(The stylus guard is a plastic cover that protects the stylus during transportation. Failing to remove this guard will not allow the needle to contact the groove of the record and no sound will be heard!)
The sound is noisy or strange.
eIf the stylus is
Sound skips.
ePlace the unit on a stable surface to avoid vibration and shock. Make sure the unit is level both front to back and side to side.
eClean the surface of the record/disc.
eDon’t use scratched, damaged or warped records/discs.
MP3
There is no sound even if the PLAY button (y) is pressed. eCheck if there are MP3 files on the USB.
Some unknown characters are displayed on the display panel.
eThis unit cannot display symbols and
Recording is not possible.
eThe USB memory stick or SD memory card does not have a recordable area. Use another USB memory stick or SD memory card.
eThe recording level is too low. Adjust the recording level. eSlide the lock switch of the SD memory card to unlock.
If normal operation cannot be obtained, unplug the power cord from the outlet and plug it again.
Beware of condensation
When the unit (or a record/disc) is moved from a cold to a warm place, or used after a sudden temperature change, there is the danger of condensation; vapor in the air could condense on the internal mechanism, making correct operation erratic or impossible. To prevent this, or if this occurs, leave the unit for one or two hours with the power turned on. The unit will stabilize at the temperature of its surroundings.
Maintenance
Always keep the turntable clean.
If the surface of the unit gets dirty, wipe with a soft cloth or use a diluted mild liquid soap. Be sure to remove any excess liquid completely. Do not use thinner, benzine or alcohol as they may damage the surface of the unit. Allow the surface of the unit to dry completely before using.
DEV BUSY
L'unité lit actuellement le support d'enregistrement (USB ou SD). Attendez quelques secondes.
READING
L'unité lit un CD, une clé USB ou une carte mémoire SD.
CLOSE
Fermez le tiroir de disque.
NO DISC
Aucun disque lisible n'a été chargé.
OPEN
Ouverture du disque.
Numéro de programme
P*
Station préréglée
Messages d'erreur
FULL
Il n'y a plus d'espace sur la clé mémoire USB ou la carte mémoire SD, ou il n'y a plus de pistes disponibles.
P FULL
40 morceaux ont été programmés. Aucun autre morceau ne peut être programmé.
PROTECT
La carte mémoire SD est protégée contre l'écriture.
REC ON
Apparaît durant l'enregistrement (la touche ne fonctionne pas)
(** est une variable).
Section amplificateur
Puissance de sortie . . . . . . . . . . . . . . . . . . . . . 3,5 W + 3,5 W Réponse en fréquence . . . . . . . . . . . . . . . . . . 50 Hz à 20 kHz Sensibilité/impédance d'entrée audio
AUX :
Niveau d'entrée maximal . . . . . . . . . . . . AUX : +6 dBV (2,0 V)
Section lecteur de CD
Réponse en fréquence . . . . . . . . . . . . 20 Hz à 20 kHz (±2 dB) Rapport signal/bruit . . . . . . . . . . . . . . . . . . . . . . Plus de 80 dB Distorsion harmonique totale . . . . . . . . . . . Inférieure à 0,1%
Section syntoniseur (Tuner)
Plage de fréquences (FM) . . . . . . . . . . 87,5 MHz à 108,0 MHz Plage de fréquences (AM) . . . . . . . . . . . 520 kHz à 1 710 kHz
Section |
|
|
Moteur | . . . . . . . |
|
Entraînement | . . . . . . . . . . . par courroie |
|
Vitesse |
| |
Pleurage et scintillement | . . moins de 0,25% (WDT) |
|
Type de cellule | . Cellule céramique stéréo |
|
Pointe | . . . . . . . . . . . . . . | FRANÇAIS |
Section | . . . . . . . . . 160 - 360 mV | |
Niveau de sortie |
|
Généralités
Alimentation nécessaire . . . . . . . . . . . . . . . . . . . 120 V, 60 Hz Consommation électrique . . . . . . . . . . . . . . . . . . . . . . . 25 W
Dimensions (L x H x P) . . . . . . . . . . . . . . 470 x 230 x 390 mm Poids . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 kg
Accessoires standard
Adaptateur pour 45 tours x 1 Télécommande
Antenne FM x 1
Antenne AM x 1
Câble stéréo à fiche RCA x 1 Mode d'emploi x 1
Carte de garantie x 1
<Aspect et caractéristiques sont sujets à modifications sans préavis.
<Poids et dimensions sont approximatifs.
<Les illustrations peuvent légèrement différer du modèle de production.
34 | 67 |
