Manuals / Kenmore / Kitchen Appliance / Refrigerator

Kenmore 795.7827, 795.7900, 795.6900, 795.6827, 795.7809, 795.76200 manual HOW to Reverse Door Handle

Models: 795.76200 795.7809 795.7827 795.6827 795.6900 795.7900

1 41

Download 41 pages 63.7 Kb

Page 15

Image 15

HOW TO REVERSE DOOR HANDLE

NOTE: Handle appearance may vary from illustrations on this page.

•Loosen the 2 set screws with a 3/32" hex wrench and remove the handle.

Loosen the handle mounting fasteners with a 1/4" hex wrench.

Fig. 41

•Unscrew the buttons with your fingers by rotating counterclockwise; they will loosen and fall free.

• Install the plug buttons on the left side.

Plug

Fig. 43

•Install the handle mounting fasteners

on the right side. Turn handle upside down.

Fig. 44	Handle MounUng
	Fastener

Install the handle by adjusting handle footprints to fit mounting fasteners. Tighten the set screws with a 3/32" hex wrench.

Page 15

Image 15

Kenmore 795.7827, 795.7900, 795.6900, 795.6827, 795.7809, 795.76200 manual HOW to Reverse Door Handle

Contents

= color number English Version Spanish French Disclaimer of implied warranties limitation of remedies One Year Limited Warranty Master Protection Agreements Page Electrical Shock Hazard Before YOU Throw Away Your OLD Refrigerator Or FreezerRecommended Grounding Method USE of Extension Cords ODurabase Freezer Drawer Model Freezer Swing Door Model Base Grille Instructions InstallationTo Install Base Grille Unpacking Your Refrigerator HOW to Remove Refrigerator Door HOW to Remove Pull OUT DrawerFor Freezer Drawer Models Replacing Refrigerator Door Ta es Top Ipprts Lower door into final position and tighten the screws HOW to Install Pull OUT Drawer REMOVING,REVERSING and Replacing Refrigerator Doors For Freezer Drawer ModelsFlat-head screwdriver for prying Pin HOW to Reverse Door Handle For Freezer Swing Models HOW to Replace Refrigerator Freezer Doors Refrigerator Doors For Freezer Swing Models 10mm or 13/32-inch socket wrenchNo Phillips head screwdriver 4inch socket wrench Pin Insert Bracket After Instructions below to align the doors After Completing the JOBLeveling and Door Closing Door Alignment Identify your control type Ensuring Proper AIR Circulation Refrigerator Adjusting Control Settings Storing Frozen Food Food Storage Guide Convenience Shelves optional on some models Refrigerator ShelvesSliding Out Shelves optional on some models To remove a sliding shelf from its metal frame Crisper Humidity Control on some models Refrigerator FeaturesPantry On some models To remove the crisper cover Crisper Cover with Lattice on InnerSurface on some models To remove the glass Door Bins Door Racks Durabase Divider on some models Dairy BINEGG BOX on some models Durabase on some models Tilting Door on some models Wire Durabase on some modelsHow to use GLIDE-OUT Drawer Basket on some models Door Liners and Gaskets General Cleaning TipsLight Bulb Replacement Outside Power Interruptions To change the freezer lightIf you choose to leave the refrigerator on while you Preparing for Vacation When YOU should SET the Icemaker Power Switch to O OFFIcemaker Normal Sounds YOU MAY Hear Before YOU Begin Power drill Tighten the Pipe Clamp Installation Instructions Choose the Valve LocationDrill the Hole for the Valve Fasten the Shut OFF Valve Start the Icemaker Connect the Tubing to the RefrigeratorTurn the Water on AT the Shut OFF Valve Plug in the Refrigerator Then Refrigerator does not OperateVibration or Rattling Noise Check if Check if Then Compressor Motor Seems to RUN TOO MuchDoors will not Close Completely Frost or ICE Crystals on Frozen Food Refrigerator Seems to Make TOO Much Noise Cubes Produced by Icemaker are TOO SmallDoors are Difficult to Open Lights do not Work Automatic Icemaker does not Work Iiiiiiiiiiiiiiiiiiiiiiii