Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
UNPACKING YOUR REFRIGERATOR
Remove tape and any temporary labels from your refrigerator before using. Do not remove any warning- type labels, the model and serial number label, or the Tech Sheet that is attached to back wall of the refrigerator.
To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids or abrasive cleaners to remove tape or glue. These products can damage the surface of your refrigerator. For
more information, see the Important Safety Instructions section.
Refrigerator shelves are installed in the shipping position.
Please reinstall shelves according to your individual storage needs.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator for cleaning or service, be sure to protect the floor. Always pull the refrigerator straight out when moving it. Do not wiggle or walk the refrigerator when trying to move it, as floor damage could occur.
3.Install this appliance in an area where the temperature is between 55 °F (13 °C)and 110 °F (43 °C.)If the temperature around the appliance is too low or high, cooling ability may be adversely affected.
[] CAUTION: Avoid placing the unit near heat sources, direct sunlight or moisture.
NOTE: For proper air circulation, best cooling and energy consumption results, maintain a minimum distance
of 2 inches (5.08cm) from adjacent items and surfaces
2"(5,08 cm) I
z'(5.o8cml | _1I_ | |
| 2" | 2" |
| (5.08 cm) | (5.08 cm) |
NEXT
1.Clean your refrigerator thoroughly and wipe off all dust accumulated during shipping.
2.Install accessories such as ice cube bin, drawers, shelves, etc., in their proper places. They are packed together to prevent possible damage during shipment.
. Let your refrigerator run for 2 or 3 hours before putting food in it. Check the flow of cold air in the freezer
compartment to ensure proper cooling. Your refrigerator is now ready for use.
•Be careful when you work with hinge, base grille, stopper etc. You may be injured.
°Do not put hands or metal sticks into air vents, base
grille or bottom of refrigerator. You may be injured or receive an electrical shock.
Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from refrigerator.
Failure to do so can result in death, explosion or fire.
INSTALLATION
1.Avoid placing the unit near heat sources, direct sunlight, or moisture.
2.To avoid vibration, the unit must be level. If required, adjust the leveling screws to compensate for unevenness of the floor. The front should be slightly higher than the rear to aid in door closing. Leveling screws can be turned easily by tipping the cabinet slightly. Turn the leveling screws clockwise ("_'_) to
raise the unit, counterclockwise (_ to lower it.
BASE GRILLE INSTRUCTIONS
To Install Base Grille
•Refrigerator door should be opened or removed. (Necessary on some models).
•Use the 2 Phillips screws provided in the literature package to attach the Base Grille.
To Remove Grille
•Open or remove refrigerator door. (Necessary on some models).
•Take out the base grille by removing the 2 screws on the bottom of the refrigerator.
9
