Kenmore 911.94752, 911.94754, 911.94759 manual Importantsafety Instructions, Step

IMPORTANTSAFETY INSTRUCTIONS

Anti-Tip Bracket (contd.)

Step 2

Anti-tip bracket installation A. Wood Construction:

Floor: Drill a 14_pilot hote in the center of each pre-marked wood floor hole position (a nail or awl may be used if a drill is not available),

AND

. Wall: Drill an angled 1/8"pilot hole (as shown in Fig, 2) in the center of each pre-marked wall hole position (a nail or awl may be used if a drill is not available).

ATTACHMENT TO WALL AND FLOOR

Bracket

Wall

Plate

or

Fig. 2

B. Mount the ANTI-TIP bracket

with the 4 screws provided as

illustrated in Fig, 2

C. Concrete Construction:

1. Hardware required:

4 each 1/4"x t t/2"lag bolt

4 each 1/2"OD sleeve anchor

=Drill the recommended size hole for the anchors into the concrete at the center of each

pre-marked concrete floor and wall hole position Install the sleeve anchor into the drilled holes and then install the lag bolts through the bracket

DO NOT OVERTIGHTEN THE BOLTS,

Step 3

Checking the installation

A. Complete the installation of the range per the installation instructions provided with it,

B. Check if the ANTI-TIPbracket is installed and engaged properly Remove the kick panel or storage drawer and inspect the REAR LEVELING LEG Make sure it fits securely into the slot See Fig, 1

4