Kenmore 790-.9663, 9664 manual Before You Call, Occurrence, Possible, Cause/Solution

Before You Call

Solutions to Common Problems

Before you call for service, review this list, It may save you time and expense, The list includes common occurrences that are not the result of defective workmanship or materials in this appliance,

OCCURRENCE	POSSIBLE	CAUSE/SOLUTION
Range is not level.	Poor installation.	Place oven rack in center of oven. Place a level on the oven rack. Adjust

leveling legs at base of range until the oven rack is level.

Be sure floor is level and is strong and stable enough to adequately support range.

If floor is sagging or sloping, contact a carpenter to correct the situation.

Kitchen cabinet alignment may make range appear unlevel. Be sure cabinets are square and have sufficient room for range clearance.

Cannot move appliance easily. Appliance must be accessible for service,

Cabinets not square or are built in too tightly. Contact builder or installer to make appliance accessible.

Carpet interferes with range. Provide sufficient space so range can be lifted over carpet.

Oven control beeps and displays any F code error (for example F11).

Surfaceelementtoo hotor not hotenough.

Surface element does not heat.

Entire appliance does not operate.

ESEC displays " - -"message.

ESEC displays any "F" message.

Electronic control has detected a fault condition. Press the STOP key pad to clear the

display and stop beeping. Reprogram oven. if fault recurs, record fault number. Press ............

the STOP key pad and call 1-800=4-MY-HOME® for assistance (See back cover).

ii!

Incorrect control setting. Make sure the correct control is on for the element to be used.

Lightweight or warped pans used. Use only flat, evenly balanced, medium or heavyweight cookware. Flat pans heat better than warped pans. Cookware materials and weight of the material affect heating. Heavy and medium-weight pans heat evenly. Because lightweight pans heat unevenly, foods may burn easily.

No power to the appliance. Check steps under "Entire Appliance Does Not Operate" in this Before You Call checklist.

Incorrect control setting. Make sure the correct control is set for the surface element to be used.

Make sure cord/plug is plugged correctly into outlet. Check circuit breakers.

Service wiring is not complete. Call 1-800=4-MY-HOME® for assistance (See back cover).

Power outage. Check house lights to be sure. Call your local electric company for service.

The ESEC Control will display " - - " in the digital display windows indicating that the ESEC has a "Lockout" condition. This condition is normal when using the cooktop lockout or Self-Clean features. Wait for the Self-Clean cycle to completely finish or if using the Cooktop Lockout feature, touch the CLOCK key pad for 3 seconds to unlock the cooktop.

The ESEC control constantly monitors the internal circuitry as well as several circuits to insure they are all operating correctly. If at any time one of these systems fails, the ESEC will immediately stop the current operation and flash an error code. If any of these error messages remain or reappear in the display, call 1-800=4-MY-HOME® (See back cover).

47