Kenmore 9664, 790-.9663 manual Warmer Drawer Removal, Ready TM Drawer

Models: 790-.9663 9664

1 50
Download 50 pages 12.65 Kb
Page 38
Image 38
Warmer Drawer Removal

Warmer Drawer Removal

Removing & Replacing Warmer Drawer

Pull up with fingerTo Remove and Replace Warmer (Warm &

Ready TM) Drawer

Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance from electric

Left Glidepower before cleaning and servicing the warmer drawer.

To Remove Warmer Drawer:

Remove shield on right glide. Pull up on left lever while pushing down on right lever.

Push down with finger

Fig. 1

1. _

Turn power OFF before removing the

warmer drawer.

 

2.Open the drawer to the fully opened position.

3.On the right glide you will find a shield attached with a hex-head screw (See Fig. 1). Use a 1!4" socket and ratchet to remove the shield.

4.Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever.

5.Pull the drawer away from the range.

To Replace Warmer Drawer:

1.Replace shield on the right glide of the drawer body.

2.Pull the bearing glides to the front of the chassis glide (See Fig. 2).

3.Align the glide on each side of the drawer with the glide slots on the range.

4.Push the drawer into the range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers "click" or the bearing glides do not feel seated remove the drawer and repeat steps 2-4. This will minimize possible damage to the bearing glides.

NOTE: The Warmer Drawer will NOT operate while in the Self-Clean and !Oven Lockout modes

Fig. 2

38

Page 38
Image 38
Kenmore 9664, 790-.9663 manual Warmer Drawer Removal, Ready TM Drawer