Kenwood CT/KXF-W Relay recording CT-2050/KXF-W6010 only, To cancel relay recording, Preparation

Relay recording (CT-2050/KXF-W6010 only)

CT-2050/203/KXF-W6010/W4010 (En/M)

This function allows to record sound continuously from deck A to B.

Since this unit is not designed for recording with metal (TYPE ) tapes, do not use metal tapes for recording.

Preparation	Make “Playback (recording) preparation”.
	0
	(If relay recording is required, insert tapes
	in both decks A and B. Select the record-
	ing mode to set to "O" or "[" only.)

19

: Keys and control used in the operations described on this page.

Relay recording

1Set the relay recording mode.

"RELAY" lights up.

RELAY REC

2Perform auto-bias adjustment. (The bias adjustment is applied to deck B.)

“AUTO BIAS”blinks. After approximately “AUTO BIAS” lightsup. 40 seconds

AUTO BIAS

3Adjust the recording level.

1Play the music source.

2Set the record-pause mode. (deck A).

3Adjust the recording balance and record-

ing level. ^

4Stop playing the music source.

ÖThe optimum bias is set in about 40 seconds, after which the deck enters the stop mode.

ÖRecording is possible even if the auto-bias adjustment operation is omitted.

4Start recording.

1Press the REC/ARM (¦) key (of deck A).

¦REC/ARM

2Play the music source from the begin- ning.

ÖRecording will start.

ÖRecording on deck B starts immediately after recording on deck A has completed.

To cancel relay recording

"RELAY" goes off.

RELAY REC

ÖPress the RELAY REC key again.

Note Relay recording cannot be performed if the REV.MODE key is set to “Ó”.