Kenwood CT/KXF-W To pause recording temporarily, Pause, To stop recording, In stop mode

How to record (CT-203/KXF-W4010; Deck B only)

CT-2050/203/KXF-W6010/W4010 (En/M)

18

To pause recording temporarily

Pause	To resume recording
8PAUSE	¦REC/ARM

ÖThe 8 indicator lights.

To stop recording

1Stop the tape transport.

CT-2050/KXF-W6010

2 7 3

CT-203/KXF-W4010

2Stop playing the source component.

How to provide non-recorded blanks between programs

In stop mode	During recording
Press successively twice.	Press once.
¦REC/ARM	¦REC/ARM

ÖAfter leaving a non-recorded blank of about 4 seconds, the deck enters the record-pause mode.

To start recording again from the biginning

The following procedure is useful when you want to cancel recording in progress and re-start it.

A non-recorded space of about 4 seconds or more should be reserved before the position where recording was started.

1Rewind during recording.

During recording in the 3 direction:

1Á￿

ÖWhen the Á (or 1) key is pressed during recording, recording is aborted and tape is rewound as shown below if there is a non-recorded space of more than 4 seconds before the recording start position.

Tape stops after 2 sec. of transport.

Re-recording

Recorded tune

Tune to be re-recorded.

During recording in the 2 direction:

1 Á￿

2Press the REC/ARM (¦) key twice.

CT-2050/KXF-W6010

¦REC/ARM

CT-203/KXF-W4010

3Replay the tune you wish to record.

4Press the REC/ARM (¦) key once.

¦REC/ARM

Blank of 4 sec. or more.

ÖIf there is no recorded tune before, the tape will be rewound then stopped.

ÖWhen re-recording from the beginning of tape, feed the leader tape (the first portion of tape that cannot be recorded) before starting re- recording.

ÖA non-recorded space of about 4 seconds is reserved on tape, then the tape transport stops.

ÖRecording starts.