Kenwood DDX7045 instruction manual ~l1Io, Removing the Hard Rubber Frame escutcheon

	.".'n.		9...	I\IIQ.tai	...to ff!..I~¥~,.)U	,...i..t )	«	ii	i<.	>	) ,.,.,,..,..., ,
. ..v..'i..		dU	...'~			, ,~	,	m'	ii.> < <.<.i.>.><		~...
R...~l'1"Io"" ,				,	un ..w,..' .w...', .'w.>...,				n.' ..,... ,.w
					.'	'N			"	.,	",...

. Removing the Hard Rubber Frame (escutcheon)

1.Engagethe catch pins on the removal tool Q) and

remove the two locks on the lower level.

Lower the frame and pull it forward as shown in the figure.

2.When the lower level is removed, remove the upper two locations.

~The frame can be removed from the top side in the

~same manner.

. Removing the Unit

1.Refer to the section <Removing the Hard Rubber Frame> and then remove the hard rubber frame.

2.Remove the Hex-head screw with integral washer (M4 x 61 on the back panel.

3.Insert the two removal tools Q) deeply into the slots on each side, as shown.

4.Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside.

~Be careful to avoid injury from the catch pins on the

~removal tool.

~~~

V

~~~~W"'

5.Pull the unit all the way out with your hands, being careful not to drop it.

English9