Kenwood DDX7045 Use a disc changer supported by the system see, Manual dimmer is set

Troubleshooting Guide

What might appear to. be a malfunctian in yaur unit may just be the result af slight misaperatian ar miswiring. Befare calling service, first check the fallawing table far passible prablems.

.General

.The fuse has blown.

An optional unit required to listen to each source is

not connected yet.

The RESET button is not pressed yet althoughthe optional unit has been connected to the system.

The "O-N"switch of the optional unit is at the "0" position.

A disc changer not supported by the system is used.

Not~lellisio,!/video image appears.

After checking for short circuits in the wires, replace the fuse with one having the same rating.

A non-connected source is not selected. See

<INSTAllATION MANUAL> and connect the unit correctly. Press the reset button (see page 4).

Set the "O-N"switch to the "N" position.

Use a disc changer supported by the system (see page 4).

. Press the reset button on the unit (see page 41.

The unit is not connected	to the parking brake	Make proper connections	according	to <INSTALLATION
detection switch.		MANUAL>.
The parking brake is not	engaged.	For safety reasons no television/video		images are
..	........	displayed while the vehicle is moving. Engaging the
		parking brake will cause images to be displayed.

	If the temperature of the monitor unit drops, the screen
	may appear darker when power is first turned on due to
	the characteristics of a liquid crystal panel. Wait a while
	after turning power on for the temperature to rise. Normal
	brightness will return.
The unit is set to auto dimmer.	When	the	unit		is set to	auto dimmer,	it is not linked to the
The illumination wire has not been connected. (If	vehicle's		light		switch.
	Make	proper		connections		according	to <iNSTALLATION
manual dimmer is set)	MANUAL>.
. AM/FMradic:> reCel>tioni~ poor ~nd/or there is noise.
The TV antenna and vehicle's radio antenna are too	Separate		the two antennas as far as possible.
close.	Turn off the			main unit.

The remote control mode selector is not set correctly.

Switch the remote control mode selector according to the source you select (see page 10).

96 English