Kenwood DDX7045 instruction manual 11m Starts or stops test signal tone output for setup

unit.

W Displays the X'over (HPF) screen.

(See <High Pass Filter Setup>, page 641

W Display the X'over (LPF) screen.

(See <Low Pass Filter Setup>, page 64)

[II Sets up the front speaker type to fine-tune for the optimal equalizer curves.

Standard: Setup for general diameter speakers

Narrow: Setup for small diameter speakers

Middle: Setup for small diameter woofer

Wide: Setup for large diameter woofer

!ill Select the speakers for Multi-channel sounds. "3/2": Center speaker, Front speaker, Rear speaker

"2/2": Front speaker, Rear speaker

"3/0": Center speaker, Front speaker

"2/0": Front speaker

[j] Set the use or no use of Sub Woofer.

[j] Displays the Channel Level Setup screen.

IUIDisplays the Car Type Set Up screen.

~	."X'OverHPF" and "X'OverLPF" can be set only
~	when "Sub Woofer" is set to "On".
	.To turn the Center speaker on in the "Multi
	channel" settings, turn "Dolby Pro Logic" (see
	page 91) on.

!liISelects a speaker to be set. (see <Channel Level>, page 62)

!illSets the speaker volume.

(see <Channel Level>, page 62)

11m Starts or stops test signal tone output for setup

check.

[l] Displays the Speaker Set Up screen.

~	.Your setup on the <Sound Effects Menu> is
~	adjusted automatically to get the best sound
	effects according to the car type and speaker you
	have set on the <Audio	Set Up> (see page 60).
	We recommend you to	complete the <Audio Set

Up> first, then set up the <Sound Effects

Menu>.

You can fine-adjust the automatic set value by

<DTA Setup> (see page 621. <Crossover Network Setup> (see page 591.or <Parametric Equalizer> (see page 88)

.Stop the test signal tone if you have finished

setting up the Channel Level. If you leave the test

signal tone on, you may not be able to set up other settings.

English 61