Kenwood DDX7045 instruction manual Random play or magazine random play has been selected

Troubleshooting Guide

does not contain the one angle.

A viewing restriction IRATING) has been set for the disc.

The DVD disc being played does not contain the recording of the selected voice or subtitle

.Disc source

No wire has been connected to the disc changer input terminal on the unit.

The specified CD is quite dirty. The CD is upside-down.

The disc is loaded in a different slot from that specified.

The disc is severely scratched.

Something is touching the disc changer.

The CD is scratched or

The computer chip in the unit is not functioning normally.

Random play or magazine random play has been selected.

is not cancelled.

The cause is that more than 10 minutes has elapsed since the vehicle ACC switch was turned OFF.

The viewing angle cannot be changed when the DVDdisc being played does not contain the recording of more than

one angle.

More than one viewing angle may be recorded only in limited sections in a disc.

. Check the viewing restriction level (RATING) setting.

Use a DVDdisc containing the recording of the selected voice or subtitle language.

Connect the wire to the disc changer input terminal on the unit.

Clean the CD.

Load the CD with the labeleQ side up.

Eject the disc magazine and check the number for the specified disc.

Try another disc instead.

Remove whatever is touching it.

If skipping happens at the same place when the car is stopped, something with the CD is wrong. Clean the CD.

. Press the reset button on the unit (see page 41.

.Turn off random play or magazine random play.

The settings for these functions remain on until the setting to off or the disc ejected, even if the power is turned off or the source changed.

The disc can only be removed within 10 minutes of the ACC switch being turned OFF. if more than 10 minutes has elapsed, turn the ACC switch ON again and press the Eject button.

98 English