Before Use
IAWARNING ,
To prevent injury and/or fire, take the following
precautions:
Ensure that the unit is securely installed. Otherwise it may fly out of place during collisions and other jolts.
When extending the ignition, battery or ground wires,
make sure to use
cable deterioration and damage to the cable coating.
To prevent short circuits, never put or leave any metallic objects le.g., coins or metal tools) inside the unit.
If the unit starts to emit smoke or strange smells, turn off the power immediately and consult your Kenwood dealer.
Do not touch the liquid crystal fluid if the LCD is damaged or broken due to shock. The liquid crystal fluid may be dangerous to your health or even fatal.
If the liquid crystal fluid from the LCD contacts your body or clothing, wash it off with soap immediately.
IACAUTION I
To prevent damage to the machine, take the following precautions:
Make sure to ground the unit to a negative 12V DC power supply.
Do not open the top or bottom covers of the unit.
Do not install the unit In a spot exposed to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing.
Do not subject the faceplate to excessive shock, as it IS a piece of precision equipment.
When replacing a fuse, only use a new one with the prescribed rating. Using a fuse with the wrong rating may cause your unit to malfunction.
To prevent short circuits when replacing a fuse, first disconnect the wiring harness.
Do not use any screws except for the ones provided. The use of improper screws might result in damage to the main unit.
You cannot view video pictures whilst the vehicle IS moving. To enJoy TV/video pictures, find a safe place to park and engage the parking brake.
INOTE I
If you experience problems during installation, consult your Kenwood dealer
If the unit does not seem to be working right, try pressing the reset button first. If that does not solve the problem, consult your Kenwood dealer.
1:;:'11
i,1
.~c~
Reset button
Screen brightness during low temperatures
When the temperature of the unit falls such as during winter, the liquid crystal panel's screen will become darker than usual. Normal brightness will return after using the monitor for a whilst.
Audio units you can control from the
DDX7015/7045 Receiver (in November of 2003):
ISet the "O-N"switch to "N" position if provided.!
Navigation units you can control from the
DDX7015/7045 Receiver (in November of 2003):
Loading and Replacing the battery
Use one lithium battery (CR2025).
Insert the batteries with the <j=)and 8 poles aligned properly, following the illustration inside the case.
1AWARNING I
Store unused batteries out of the reach of children. Contact a doctor immediately if the battery is accidentally swallowed.
Do not set the remote on hot places such as above the
~'" dashboard.
~ .The provided batt~ries B.re i~tended for use in operation ~ .checking, and their service life may be short.
When the remote controllabledistancebecomes short, replace both of the batteries withnew ones
Cleaning the panel and monitor
When the operator panel and monitor panels are dirty, wipe and clean them using a soft cloth (such as a commercially available silicon coated cloth). When contaminated excessively, clean them using a cloth dipped in a neutral detergent first, then remove the detergent using a dry cloth.
Do not use a hard cloth and a volatile chemical (such as an alcohol). If used, the panel surface may be scratched or printed letters may be erased.
Cleaning the disc slot
As dust can accumulate in the disc slot, clean it occasionally. Your discs can get scratched if you put them in a dusty disc slot.
Lens Fogging
Right after you turn on the car heater In cold weather, dew or condensation may form on the lens in the disc player of
the unit. Called lens fogging, discs may be impossible to play. In such a situation, remove the disc and wait for the
condensation to evaporate. If the unit still does not operate normally after a whilst, consult your Kenwood dealer.
4 English
