Setup Menu

Navigation Setup

You can set Navigation parameters.

1Display the Navigation Setup screen

Touch [] > [] > [Navigation]. (page 67)

2Set each item

[NAV Interrupt Speaker] Selects speakers used for voice guidance of the navigation system. ( "Front All") "Front L": Uses the front left side

speaker for voice guidance. "Front R": Uses the front right side

speaker for voice guidance.

"Front All": Uses both front speakers for voice guidance.

[NAV Voice Volume] Adjusts the volume for voice guidance of the navigation system.

( DNX series: "25", DDX series: "21") [NAV Mute] Mutes the volume of rear speakers during voice guidance of the

navigation system. ( "ON")

When turned "ON", the volume level drops for voice guidance.

[Navigation Input] Selects a navigation system connection. ( "RGB") (DDX series only)

"RGB": Allows the Kenwood’s Navigation System to connect via its interface cable.

"AV-IN": Allows a third-party navigation system to connect via the AV INPUT1 port.

"OFF": Must be used if no navigation system is connected. (The navigation display is cancelled when the AV source is switched.)

[On Screen Navigation] Sets an on-screen display of the navigation screen. ( "OFF") (DDX series only) "Auto": Information is displayed for 5

seconds when updated. (Example : when the track/file/song has changed to the next one.)

"OFF": Information is not displayed.

⁄

•[On Screen Navigation]

It can be set only when [Navigation Input] is set to "AVIN".

DSP Bypass Control (DNX7/ DDX7 series)

Temporarily bypassing DSP (Digital Signal Processor) System.

1Display the Audio SETUP screen

Touch [] > [] > [Audio SETUP]. (page 67)

2Set the DSP Select

[Bypass] There is no effect by DSP. [Through] There is an effect by DSP.

⁄

•When the mode is set to [Bypass], DSP System cannot be adjusted.

82 DNX series DNX7360BT/ DNX7360BTM