Before Use

2WARNINGTo prevent injury or fire, take the following precautions:

•To prevent a short circuit, never put or leave any metallic objects (such as coins or metal tools) inside the unit.

•Do not watch or fix your eyes on the unit’s display when you are driving for any extended period.

How to reset your unit

•If the unit or the connected unit fails to operate properly, press the Reset button. The unit returns to factory settings when the Reset button is pressed.

•Remove the USB device before pressing the Reset button. Pressing the Reset button with the USB device installed can damage the data contained in the USB device. For how to remove the USB device, see <How to play media> (page 16).

•When the unit is turned on after pressing the Reset button, the Initial SETUP screen is displayed. Refer to <Initial Setup> (page 100).

Reset button

Cleaning the Unit

If the faceplate of this unit is stained, wipe it with a dry soft cloth such as a silicon cloth. If the faceplate is stained badly, wipe the stain off with a cloth moistened with neutral cleaner, then wipe it again with a clean soft dry cloth.

¤

•Applying spray cleaner directly to the unit may affect its mechanical parts. Wiping the faceplate with a hard cloth or using a volatile liquid such as thinner or alcohol may scratch the surface or erases characters.

4 DNX series DNX7360BT/ DNX7360BTM

About the Terminals of the Unit and Faceplate

•To prevent deterioration, do not touch the terminals of the unit and faceplate with your fingers.

•If the terminals on the unit or faceplate get dirty, wipe them with a clean soft dry cloth.

Lens Fogging

When you turn on the car heater in cold weather, dew or condensation may form on the lens in the disc player of the unit.

Called lens fogging, this condensation on the lens may not allow discs to play. In such a situation, remove the disc and wait for the condensation to evaporate. If the unit still does not operate normally after a while, consult your Kenwood dealer.

Handling discs

•Do not touch the recording surface of the disc.

•Do not stick tape etc. on the disc, or use a disc with tape stuck on it.

•Do not use disc type accessories.

•Clean from the center of the disc and move outward.

•When removing discs from this unit, pull them out horizontally.

•If the disc center hole or outside rim has burrs, use the disc only after removing the burrs with a ballpoint pen etc.