Kenwood KDC-MP635 G-AnalyzerCalibration setup, G-Analyzervehicle class setup, G-Analyzervehicle weight setup, input, > "CAL, Display, General features, "HP SET" > "CLASS

18

5

4

3

General features

Display Type F	2 Select the weight numbers
In Standby mode		Turn the Control knob.
G-Analyzer Calibration setup
		⁄
G-Analyzer requires calibration for horizontal
		• The weight input range is between 1000-9999 lbs.
acceleration and braking.	3 Select the digits to enter
⁄
		Push the Control knob towards right or left.
• To ensure accurate calibration, go through the following	4 Repeat steps 2 and 3, and complete the weight
steps at a level place where you can move the vehicle		input.
straight ahead.	5 Exit G-Analyzer vehicle wight setup mode
1 Park the vehicle in a horizontal location
		Press the Control knob.
2 Enter G-Analyzer Calibration setup mode
Using the Control knob, select "DISP" > "GMA"
> "CAL".
For the operation method, refer to <Function	Display Type F
Control mode> (page 10).	In Standby mode
"G-CALIBRATION" is displayed.	G-Analyzer vehicle class setup
Start Calibration of horizontal direction	Enter vehicle class to calculate horsepower.
Press the Control knob.	1 Enter G-Analyzer vehicle class setup mode
Once "Move Forward" appears on the display, the
vehicle must be advanced.		Using the Control knob, select "DISP" > "GMA" >
Start Calibration of straight direction		"HP SET" > "CLASS".
		For the operation method, refer to <Function
Start moving the vehicle ahead.
		Control mode> (page 10).
Calibration of straight direction automatically starts.
		"CLASS SELECT" is displayed.
When the Calibration is finished, "Calibration OK" is
	2 Select vehicle class
displayed.
⁄		Turn the Control knob.
		Each time you push the knob, the vehicle class
• If you fail to complete the calibration, "No Calibration" is
		alternates between the modes shown in the table
displayed. In such a case, repeat steps 1 through 4.
		below.
Exit G-Analyzer Calibration setup mode
		Display
Press the [FNC] button.
		"Mid Size"
		"Full Size"
		"SUV"
Display Type F		"Van/ Mini-Van"
		"Pickup Truck"
In Standby mode
		"Sporty"
G-Analyzer vehicle weight setup
		"Compact"
Enter vehicle weight to calculate horsepower.	3 Exit G-Analyzer vehicle class setup mode
1 Enter G-Analyzer vehicle weight setup mode
		Press the Control knob.
Using the Control knob, select "DISP" > "GMA" >
"HP SET" > "WEIGHT".
For the operation method, refer to <Function
Control mode> (page 10).
"WEIGHT INPUT" is displayed.
English