Hold Error: | The protective circuit in the unit activates |
| when the temperature inside the automatic |
| disc changer exceeds 60°C (140°F), stopping |
| all operation. |
| ➪ Cool down the unit by opening the |
| windows or turning on the air conditioner. |
| As the temperature falls below 60°C |
| (140°F), the disc will start playing again. |
No Name: | Attempted to display DNPS during the CD |
| play having no disc names preset. |
Waiting: | Text for the Satellite Radio tuner source is |
| being received. |
Load: | Discs are being exchanged in the Disc |
| changer. |
Reading: | The unit is reading the data on the disc. |
IN (Blink): | The CD player section is not operating |
| properly. |
| ➪ Reinsert the CD. If the CD cannot be |
| ejected or the display continues to flash |
| even when the CD has been properly |
| reinserted, please switch off the power |
| and consult your nearest service center. |
Protect (Blink): The speaker wire has a
➪Wire or insulate the speaker cable properly and press the reset button. If the "Protect" code does not disappear, consult your nearest service center.
Unsupported File:
An Audio file is played with a format that this unit can’t support.
➪
Copy Protection:
A
➪
DEMO MODE (Blink):
The Demonstration mode has been selected.
➪The <Demonstration mode Setting> (page
40)is ON. Turn it OFF.
No Device: | The USB device is selected as a source |
| although no USB device is connected. |
| ➪ Change the source to any source other |
| than USB. Connect an USB device, and |
| change the source to USB again. |
N/A Device: | An unsupported USB device is connected. |
| ➪ For the supported USB devices, refer to |
| <http://www.kenwood.com/usb/>. |
No Music Data/ Error 15:
•The connected USB device contains no playable audio file.
•Media was played that doesn’t have data recorded that the unit can play.
USB Error: | The connected USB device is rated a current |
| capacity higher than the allowable limit. |
| ➪ Check the USB device with reference to |
| <http://www.kenwood.com/usb/>. |
| Some trouble may have occurred to the |
| connected USB device. |
| ➪ Change the source to any source other |
| than USB. Remove the USB device. |
iPod Error: | Connection to the iPod has failed. |
| ➪ Remove the USB device and then |
| reconnect it. |
| ➪ Confirm that the software for the iPod is |
| the latest version. |
USB REMOVE: | The Remove mode has been selected for the |
| USB device. You can remove the USB device |
| safely. |
English 49