Bass Q Factor

"BASS Q FACTOR"

1.00/1.25/1.50/2.00

Bass Extend

"BASS EXT"

OFF/ON

Middle level

 

 

Adjustment Item

Display

Range

Middle Center Frequency

"MIDDLE FRQ"

0.5/1.0/1.5/2.0 kHz

Middle Q Factor

"MIDDLE Q FACTOR" 1.00/2.00

Treble level

 

 

Adjustment Item

Display

Range

Treble Center Frequency

"TREBLE FRQ"

10.0/12.5/15.0/17.5 kHz

5Exit the Detail Audio Control mode Press the [VOL] knob for at least 1 second.

⁄

•When you set the Bass Extend to ON, low frequency response is extended by 20%.

•You can exit the Audio Control mode at anytime by pressing any button except for [VOL] knob and [ATT] button.

Audio Setup

Setting the Sound system, such as Cross over Network.

1Select the source to adjust Press the [SRC] button.

Refer to <Selecting the Source> (page 7).

2Enter Audio Setup mode

Press the [VOL] knob for at least 1 second.

3Select the Audio Setup item to adjust Press the [VOL] knob.

Each time you press the knob, the item to be adjusted alternates between the items shown in the table below.

4Setup the Audio item Turn the [VOL] knob.

Adjustment Item

Display

Range

Front High Pass Filter

"HPF-F Fc"

Through/40*/60*/80/100/120/

 

 

150/180/220* Hz

Rear High Pass Filter

"HPF-R Fc"

Through/40*/60*/80/100/120/

 

 

150/180/220* Hz

Low Pass Filter

"LPF-SW Fc"

50*/60/80/100*/120/

 

 

Through Hz

Subwoofer Phase

"SW PHASE"

Reverse (180°)/ Normal (0°)

Volume offset

"VOL-OFFSET" –8 — ±0 (AUX: -8— +8)

Loudness

"LOUD"

OFF/ON

Dual Zone System

"2 ZONE"

OFF/ON

⁄

•* Function of KDC-X791/MP735U.

•Volume offset: Sets each source’s volume as a difference from the basic volume.

•Loudness: Compensates for low and high tones

during low volume. (Only the low tone is compensated for when the tuner is selected as a source.)

•Dual Zone System

Main source and sub source (Auxiliary input) output Front channel and Rear channel separately.

-Set up the channel of sub source by <Dual Zone System Setting> (page 36).

-Select Main source by [SRC] button.

-Adjust the volume of Front channel by [VOL] knob.

-Adjust the volume of Rear channel by <Audio Control> (page 8).

-The Audio Control has no effect on sub source.

•You can use the Dual Zone System with the Auxiliary input sources listed below.

-Internal auxiliary input. (KDC-X791/MP735U only)

-CA-C1AX/ CA-C2AX (optional accessory) connected to this unit directly. (KDC-MP635 only)

5Exit Audio Setup mode

Press the [VOL] knob for at least 1 second.

English 9