In Standby mode

G-Analyzer Calibration Setup

G-Analyzer requires calibration for horizontal acceleration and braking.

⁄

•To ensure accurate calibration, go through the following steps at a level place where you can move the vehicle straight ahead.

1Park the vehicle in a horizontal location

2Enter G-Analyzer Calibration setup mode (In

Display Type F)Select “DISP” > “GMA” > “CAL”.

For how to select Function Control item, refer to <Function Control> (page 6).

“G-CALIBRATION” is displayed.

3Start Calibration of horizontal direction Press the Control knob.

Once “Move Forward” appears on the display, the vehicle must be advanced.

4Start Calibration of straight direction Start moving the vehicle ahead.

Calibration of straight direction automatically starts. When the Calibration is finished, “Calibration OK” is displayed.

⁄

•If you fail to complete the calibration, “No Calibration” is displayed. In such a case, repeat steps 1 through 4.

5Exit G-Analyzer Calibration setup mode Press the [FNC] button.

G-Analyzer Stop Watch

The control of stop watch can be started by G- Analyzer function.

¤

• Do not use G-Analyzer stop watch on the Public roads.

1Enter G-Analyzer Stop Watch mode (In DisplayType F)Select “DISP” > “GMA” > “STOP.W”.

For how to select Function Control item, refer to <Function Control> (page 6).

“STOP WATCH” is displayed.

2Make the counter ready Press the Control knob. “Ready” is displayed.

3Start Count

When G in the vertical direction is detected during the travel, the count automatically starts. “Running” is displayed.

4Stop Count

Press the Control knob. “Stop” is displayed.

When you Reset the Count (While “Stop” is displayed)

Press the Control knob for at least 1 second.

5Exit G-Analyzer Stop Watch mode Press the [FNC] button.

⁄

•Pressing the Control knob in step 3 allows you to start counting.

•Pressing the Control knob in step 4 allows you to restart counting.

English 13