Connecting Wires to Terminals
To USB device USB connector (1m)
⁄Do not remove the cap when you do not use the USB cable. The connector will cause the unit to malfunction if it gets in touch with any metallic part of the vehicle.
Wiring harness (Accessory1)
Steering remote control |
|
(Light Blue/Yellow) | Rear output |
| |
L | R |
REMO.CONT | Front output |
To use the steering | Sub Woofer output |
wheel remote control |
|
feature, you need to |
|
an exclusive remote |
|
adapter (not supplied) |
|
matches your car is |
|
required. |
|
| FM/AM antenna input |
| AUX input (Stereo) |
| Use the |
Fuse (10A) | not have any resistance. |
| |
| To Kenwood disc changer/ External optional accessory |
| ⁄ To connect these leads, refer to the relevant |
| instruction manuals. |
White |
|
White/Black | To front left speaker |
Gray |
|
Gray/Black | To front right speaker |
Green |
|
Green/Black | To rear left speaker |
Purple |
|
Purple/Black | To rear right speaker |
If no connections are made, do not let the wire come out from the tab.
Power control wire (Blue/White)
P.CONT
Motor antenna control wire (Blue)
ANT.
CONT
TEL mute wire (Brown)
MUTE
Dimmer control wire (Orange / White)
ILLUMI
Car fuse box
Ignition wire (Red) | ACC |
Battery wire (Yellow)
Ground wire (Black) · (To car chassis)
When using the optional power amplifier, connect to its power control terminal.
Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the
Connect to the terminal that is grounded when either the telephone rings or during conversation.
⁄To connect the Kenwood navigation system, consult your navigation manual.
To car light control switch
Ignition key switch
Car fuse box (Main fuse)
–
+
Battery
34