Kenwood KM300, KM800, KM400, KM600 manual troubleshooting, problem

troubleshooting

problem

●The whisk or K-beater knocks against the bottom of the bowl or isn’t reaching the ingredients in the bottom of the bowl.

solution ● Adjust the height. Here’s how:

1Unplug.

2Raise the mixer head and insert the whisk or beater.

3Hold it, then loosen the nut

4Lower the mixer head.

5Adjust the height by turning the shaft. Ideally the whisk/K-beater should be almost touching the bottom of the bowl

6Raise the head, hold the whisk/K-beater and tighten the nut.

to fit and use your round/D-shaped splashguard (if supplied)

1Raise the mixer head until it locks.

2Fit the bowl onto the base.

3 Push the splashguard on until fully located . The hinged section

should be positioned as shown round and D-shaped

4Insert required tool.

5Lower the mixer head ensuring the splashguard follows the shape of the bowl.

●During mixing, ingredients can be added directly to the bowl via the hinged section of the splashguard.

●You do not need to remove the splashguard to change tools.

6Remove the splashguard by raising the mixer head and sliding it down.

3