General features

English

TEL Mute

Shut down the audio system temporarily whenever an incoming call is received.

NOTE

The function will not work if a cable is not connected to the car phone.

When the telephone rings:

When a call is received, "CALL" is displayed and all the unit functions are temporarily interrupted.

Restoring Original Unit Source During Phone Call: Press the SRC button.

"CALL" disappears from the display, and the volume of the original source is restored gradually.

Turning TEL Mute Function Off After Phone Call:

Hang the phone up.

"CALL" disappears from the display.

The original source (i.e., the one used before the phone call) is returned to automatically, and the volume restored gradually.

Removing the Faceplate

The faceplate can be detached from the unit, helping to deter theft.

Removing the faceplate:

1Choose the way from among the following and open the faceplate.

Turn the ignition off, hold down the SRC button for one second or more, or press the left part at the upper side of the faceplate (as illustrated on p.8) for as many times as you have preset in the "Manual Open Button Setting" (OPEN SW #) in the menu when the control panel has been hidden.

2Set the faceplate's angle adjustment switch to "0" to set the faceplate angle to the vertical.

For details, refer to "Faceplate Angle Adjustment" (page 8).

NOTE

If the faceplate's angle adjustment switch is not set to "0" when mounting the faceplate on the faceplate bracket, it may be difficult to mount the faceplate or the faceplate may not be securely attached and could fall off.

Set the angle adjustment switch to "0" before removing the faceplate.

3Slide the faceplate lock switch to the left during the period which you have set in the "Time setting for removing the faceplate" in the menu.

Faceplate lock switch

4Holding the centre part of the faceplate, pull it out. The faceplate bracket will automatically close.

2CAUTION

•When removing the faceplate, pull it out only when it is fully open. The detachment of the faceplate whilst it is moving might result in damage to the unit.

•Do not apply excessive force to the faceplate bracket without attaching the faceplate. Doing so will cause the faceplate bracket to be deformed.

•Do not touch the connector on the faceplate bracket after removing the faceplate. Touching the connector may cause damage to the unit.

•Do not touch two metal parts on both sides of the faceplate bracket. Touching those parts may injure you.

NOTE

•Sliding the faceplate lock switch cause the unit’s power to turn off. If you want to operate the unit again, remove the faceplate from the faceplate bracket completely and then reattach it.

— 10 —