Kenwood Mounting Example, Locking the faceplate to the unit, ■Locking the faceplate to the unit, Attaching Steering Remote Control (Optional for the KRC-778R/778RV)

Locking the faceplate to the unit■Locking the faceplate to the unit

If you want to lock the faceplate to the unit so that it does not fall off, follow the directions below.

1Refer to the function "Removing the faceplate" (page 10) and remove the faceplate.

2Insert the provided screw into the hole at the centre of the bottom side of the faceplate which you have removed from the unit.

Accessory5

3Refer to the section "Removing the faceplate (page 10)" and then reattaching the faceplate.

2CAUTION

Never insert the taptite screws (ø2 ⋅ 6 mm) in any other screw holes than the one specified. If you insert it in another hole, it will contract and may cause damage to the mechanical parts inside the unit.

Attaching Steering Remote Control (Optional for the KRC-778R/778RV)Mounting Example

6

7 8

9

Attach the operation section and the light emitting section of the Steering Remote Control as shown above.

Be sure to attach them to positions that can ensure proper operation.

2CAUTION

•Clean dirt and oil from the positions where the Steering Remote Control sections are to be attached.

•If the attached position is cold, warm it before attaching.

•The position should be selected so that the product does not come in the way of steering operation.

•Do not attach anything on the surface of a steering wheel incorporating an air bag.

•Before finally affixing the transmitter, check various angles to find an orientation that provides faithful operation.

— 43 —