Kenwood The, A–7, A–4, The, Unit, Unit, Unit, Vehicle, Vehicle, Pin (Red), Installtion, A–7Pin (Red), Pin (Yellow), ■Installation, A–4Pin (Yellow), A–4Pin (Yellow)

2WARNING

Connecting Cables to Terminals

Connecting the ISO Connector (see p.40)

The pin arrangement for the ISO connectors depends on the type of vehicle you drive. Make sure to make the proper connections to prevent damage to the unit.

The default connection for the wiring harness is described in 1 below. If the ISO connector pins are set as described in 2 or 3, make the connection as illustrated.

1(Default setting) The A-7 pin (red) of the vehicle's ISO connector is linked with the ignition, and the A-4 pin (yellow) is connected to the constant power supply.

Unit	Vehicle
Ignition cable (Red)	A–7 Pin (Red)
Battery cable (Yellow)	A–4 Pin (Yellow)

2The A-7 pin (red) of the vehicle's ISO connector is connected to the constant power supply, and the A-4 pin (yellow) is linked to the ignition.

Unit Vehicle

Installtion■Installation

Firewall or metal support

Screw (M4X8) (commercially available)

Self-tapping

screw	Metal mounting
	strap
(commercially
	(commercially
available)
	available)
NOTE

Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place.

Ignition cable (Red)	A–7	Pin (Red)
Battery cable (Yellow)	A–4	Pin (Yellow)

3The A-7 pin (red) of the vehicle's ISO connector is not connected to anything, whilst the A-4 pin (yellow) is connected to the constant power supply (or both the A-7 (red) and A-4 (yellow) pins are connected to the constant power supply).

Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip).

Unit

Ignition cable (Red)

Battery cable (Yellow)

Vehicle

Connect to a power source that can be turned on and off with the ignition key.A–4 Pin (Yellow)

2CAUTION

To attach this unit, make sure the front of the control panel faces you and fit it into the mounting sleeve by pressing the four corners of the hard rubber frame at the same time.

Do not apply strong pressure to other sections than the corners; otherwise troubles such as the impossibility of opening or closing the panel may result.

— 41 —