Kenwood KRF-V8030D, VR-409 Recording audio (analog sources), Recording video, Recording audio (digital sources), MODE, MODE, MODE, A-REC, A-REC, M-REC, A-REC, DIMMER, DIMMER, MONITOR

Recording

Recording audio (analog sources)

18

MONITOR

INPUT SELECTOR

Recording a music source

1Use the INPUP SELECTOR knob to select the source (other than "MD/TAPE") you want to record.

2Set the cassette deck or MD recorder to record.3Start playback, then start recording.

Recording video

1Use the INPUT SELECTOR to select the video source (other than “VIDEO1”) you want to record.

2Set the video deck connected to VIDEO 1 to record.

• Select the REC MODE to record a digital input source.

3Start playback, then start recording.

• With certain video software, recording may not be normal due to the

copy guard condition.§

Recording audio (digital sources)

Switch on the REC MODE to record a digital input source. Usually use the A-REC MODE to record audio input sources.

When the digital mode changes during recording in the A-REC MODE, the audio may be interrupted momentarily. To record the audio from the beginning of the digital mode change, use the M-REC MODE.

Operations

Recording tapes or MDsMONITOR = MD/TAPE recording1 Press the MONITOR key.

FM AUTO SOUND DIGITAL

AM PRO LOGIC S.DIRECT

MHz 3 STEREO MONITOR

kHz DOWN MIX DSP

2Use the INPUP SELECTOR knob to select a source other than "MD/TAPE."

3Start playback on the cassette deck connected to the MONITOR jacks and start recording on the cassette deck connected to the MD/TAPE jacks.

MD/TAPE = MONITOR recording1Use the INPUP SELECTOR knob to select "MD/TAPE."

2Start playback on the cassette deck connected to the MD/TAPE jacks and start recording on the cassette deck connected to the MONITOR jacks.

•To copy tapes using a double cassette deck, refer to the instruction manual of the double cassette deck.

MONITOR function (analog sources only)

You can connect a cassette deck or graphic equalizer to the MONITOR jacks of the receiver. If a graphic equalizer is connected, the MONITOR key should be left in the on position. Alternately, if a cassette deck equipped with a 3-head system is connected to the MONITOR jacks, you will be able to monitor the just-recorded signal while making recordings on the cassette deck. By switching the MONITOR key on and off, you can compare the sound of the source signal and the just- recorded signal. For more information, refer to the instruction manual of the connected component.

Recording music in A-REC MODE

DIMMER

INPUT SELECTOR

1Use the INPUT SELECTOR to select the source (CD, DVD, VIDEO2, or VIDEO3) you want to record.

2Set the cassette deck or MD recorder to record.

3Press and hold the DIMMER key for more than 2 seconds to select the A-REC MODE.

•The mode changes every 2 seconds as shown below.

1REC MODE off : The digital input record mode is switched off.

2A-REC MODE : The digital input signals (DTS, Dolby Digital, or PCM) are identi- fied automatically and converted into stereo signals that are ready

for recording.

3M-REC MODE : The input signal type at the moment this mode is selected is held throughout this mode.

FM	DIGITAL
AM PRO LOGIC S.DIRECT
MHz 3 STEREO MONITOR
kHz DOWN MIX	DSP
FM AUTO SOUND DIGITAL		AUTO
AM PRO LOGIC S.DIRECT		MEMO
MHz 3 STEREO	MONITOR	ST.
kHz DOWN MIX	DSP	TUNED

4Start playback, then start recording.

•If the audio reproduction stops in the middle due to change in the input signals, etc., press the DIMMER key.