Troubleshooting

Receiver/Tuner

I want to clear all the items in PowerTouch and make it to the factory -set default condition.

•While holding the CONFIRM and VOLUME DOWN buttons together, press and release the RESET button under the battery cover . Do not release the CONFIRM and VOLUME DOWN buttons until a short beep indicating the completion of setting is heard.

After the above, all settings are reset to the factory settings.

Receiver/Tuner

My receiver won’t turn on and the STANDBY indicator is flashing. Your receiver is in the “protection” mode.

Check that:

•The speaker system’s impedance is not too low. See Chapter One of the Connections and Setup Guide.

•The speaker wires are not short-circuited. Test the wires as follows to find the shorted wire and replace it:

1 Turn off the receiver, disconnect the positive and negative speaker wires of the RIGHT FRONT speaker from the receiver, and turn the receiver back on.

2 If the STANDBY indicator stops flashing, replace this wire.

3 If the STANDBY indicator does not stop flashing, turn off the re- ceiver, reconnect the speaker wires, and repeat the first step for the next speaker.

4Continue until you have isolated and replaced the shortedwire.

5 See Chapter One of the Connections and Setup Guide.

If none of the above solutions work, reset the microprocessor:

1.Turn the receiver off. (The Power button is OFF position.)

2.Press ON/STANDBY button while pressing and holding the Power button.

The following settings are cleared:

•The device set as input (Tuner is selected by default)—see “How Do I Operate Devices?” on page 35 of this manual.

•The volume setting (-48dB is selected by default)—see “Adjusting the Volume” on page 11 of this manual.

104