Kenwood KVC-1000 instruction manual Removing the Hard Rubber Frame

On cars where there is no compartment in the centre for installing a car audio unit:

Use the spacer (Accessory 0) to affix the centre unit sleeve and the sleeve attached to the main unit in such a way that they are correctly aligned both depthwise and horizontally.

On cars lacking a centre	P
	U
compartment

Accessory 0

U

English

Removing Unit

■Removing the Hard Rubber Frame

1Engage the catch pins on the removal tool and remove the two locks on the lower level.

Lower the frame and pull it forward as shown in the figure.

Lock Catch

Accessory 4

2When the lower level is removed, remove the upper two locations.

NOTE

The frame can be removed from the top side in the same manner.

■Removing the Unit

1Refer to the section “Removing the Hard Rubber Frame” and then remove the hard rubber frame.

2Remove the Hex-head screw (Accessory 9) with integral washer (M4⋅8) on the back panel.

Catch facing up

3Insert the two removal tools deeply into the slots on each side, as shown.

2CAUTION

Be careful to avoid injury from the catch pins on the removal tool.

4Lower the removal tool toward the bottom, and pull out the unit halfway whilst pressing towards the inside.

5Pull the unit all the way out with your hands, being careful not to drop it.

31